A、 This Specification was issued by the General Aviation Manufacturers Association.
B、 This Specification was revised by the General Aviation Manufacturers Association.
C、 This Specification was compiled by the General Aviation Manufacturers Association.
答案:C
A、 This Specification was issued by the General Aviation Manufacturers Association.
B、 This Specification was revised by the General Aviation Manufacturers Association.
C、 This Specification was compiled by the General Aviation Manufacturers Association.
答案:C
A. STE 对技术翻译来说是毫无意义的。
B. STE 对技术翻译来说是宝贵的支持
c、 STE 是对技术文件理解的宝贵支持。
A. When hydraulic system B engine drive pump pressure is under normal conditions, the hydraulic power
transfer unit system supplies standby hydraulic pressure to the leading edge flaps and slats.
B. The hydraulic power transfer unit system is provide spare hydraulic pressure to the leading edge flaps and
slats when hydraulic system B engine-driven pump pressure is abnormal.
C. The hydraulic power transfer unit system supplies alternate hydraulic pressure to the leading edge flaps
and slats when hydraulic system B engine-driven pump pressure is below normal
A. 显示器顶部和左侧角落的数字指向相关页面。
B. 显示器左上角的数字代表手册对应页码。
C. 显示器左上角的数字代表相关页面。
A. 在此种情况下,文件的标题页和目录页必须遵循每一部分给出实际出版日期。
B. 在此种情况下,文件每部分之前的标题页和目录页必须标明实际出版日期。
C. 在此种情况下,标题和目录页要放在文档每个部分之前,并必须给出实际出版日期。
A. Use a hole instrument to examine the turbine internally
B. Use a borescope to examine the combustor internally.
C. Use a hole instrument to examine the combustor externally.
A. Movement of the center of gravity is not depending on the loads on the wings.
B. Movement of the center of gravity is relative with the loads on the wings.
C. Movement of the center of gravity is regardless to the loads on the wings.
A. There are trim tabs at the rear of both ailerons.
B. There are trim tabs at the rear of both flaps.
C. There are trimmable stabilizers at the rear of both elevators.
A. 为了获得正确的间隙,需要增加特殊的垫片。
B. 为了获得正确的间隙,按需增加特殊的垫片。
C. 要获得正确的间隙,需要增加特定的垫片。
A. Check such system to determine the cause of interference.
B. Examine part of the system to find the cause of the interference.
C. Examine all of the system to find the cause of the interference.
A. Handbooks shall be revised easily.
B. Handbooks should not be revised easily.