A、 Repair the broken seals.
B、 Repair the damaged sealant
C、 Repair the damaging sealant
答案：A
A、 Repair the broken seals.
B、 Repair the damaged sealant
C、 Repair the damaging sealant
答案：A
A. 浸泡元件四个小时。
B. 冲洗元件四个小时。
C. 打磨元件四个小时。
A. The repair limits are not permitted as special equipment is required.
B. The repair limits are not mentioned as special equipment IS required.
C. The repair limits are not set as special equipment is required.
A. Correct punctuation is important because it shows that the different parts of the text are reconnected and
prevents miscomprehension.
B. Correct punctuation is important because it shows how the different parts of the text are independent and
prevents accumulation.
C. Correct punctuation is important because it shows how the different parts of the text are related and
prevents ambiguity.
A. 把上凸轮放到与拆下时所做标记一致的位置。
B. 上部卡箍安装的位置应该与拆卸标记保持一致。
A. Access doors and panels within the area are recognized by the number of the area and two or three letter
suffix.
B. The area number and a postfix with two or three letters identifies the access doors and panels in an area.
C. The identification of the access panels and doors is accomplished by the zone number suffix.
A. The Federal Aviation Regulations 'require "maximum continuous power.to be used during airframe and
engine combination certification to show obedience with certain criteria.
B. Federal aviation regulations require "maximum continuing power" to be used during the certifying of the
airframe and engine to meet certain criteria.
C. Federal aviation regulations,
"maximum continuous power", are used to show compliance with certain standards.
A. 从右侧页面开始记录每个部分
B. 每个部分都要从右侧页面开始
C. 每个部分都写在右侧页面上
A. Augment the pressure slowly (no less than one turn each minute)
B. Increase the pressure slowly (not more than one turn each minute)
c、 Release the pressure slowly (not more than one turn each minute).
A. Install packing and support rings on bearing Glide bearing into cylinder until it is bottomed.
B. Install packing and backward rings on bearing. Slash bearing into cylinder until the bottom is visible
C. Install packing and alternative rings on bearing. Skid bearing into cylinder until you see the bottom.
A. Movement of the center of gravity is not depending on the loads on the wings.
C. Movement of the center of gravity is regardless to the loads on the wings.
