A、 指导谁以及如何与制造商工厂的技术人员联系,以帮助修理或者更换未包含在外标准修理范围内的损坏的
物品
B、 指导谁以及如何与制造商工厂的技术人员联系,以帮助修理或者更换损坏且是不标准损伤的物品
C、 指导谁以及如何与维修工厂的技术人员联系,以帮助修理或者更换未包含在标准修理范围内的损坏物品
答案：A
A、 指导谁以及如何与制造商工厂的技术人员联系,以帮助修理或者更换未包含在外标准修理范围内的损坏的
物品
B、 指导谁以及如何与制造商工厂的技术人员联系,以帮助修理或者更换损坏且是不标准损伤的物品
C、 指导谁以及如何与维修工厂的技术人员联系,以帮助修理或者更换未包含在标准修理范围内的损坏物品
答案：A
B. 做这个程序需要两个小时
C. 两个小时必须完成这个程序
A. The factory's policy of providing consulting remains unchanged.
B. The factory has been maintaining technical and component support within the policy scope.
C. The factory's policy on providing technical and component support has change from the past.
A. Definitions in this manual shall be conformed with those in the Federal Aviation Legislations.
B. Definitions in the handbook shall be consistent with definitions contained in the Federal Aviation
Regulations.
C. Definitions in the Federal Aviation Regulations shall be consistent with definitions contained in the
handbook.
A. The data may be supplemented by brief descriptions of additional Characteristics or features if desired.
B. If necessary ,the detail may supplement some simple descriptions of additional characteristics or properties.
C. lf desired. The detail may be added by simple presentations of additional values or properties.
A. 用于指示低压的压力计使用更灵活的管子,更容易展开和卷绕。
B. 用于指示较低压力的仪表使用更易弯曲的管子,线圈更易散开和缠绕。
C. 用于指示较低压力的压力表使用的软管更加柔软,可以随时解开和盘绕。
A. The total quantity of fuel in the center tank is 5000 Ib.
B. The Total Fuel Quantity of the main tank is 5000 pounds.
C. The total fuel consumption from the center tank is 5000 pounds.
A. Refer to the general information in addition to engine operation limits, guidelines and special procedures.
B. For general information, refer to engine operation limits; guidelines and special procedures.
C. Refer to engine operation limits, guidelines and special procedures be sides general information.
A. Put down a face mask and protective clothing.
B. Put on a face goggle and protective clothing.
C. Put on a face mask and protective clothing.
A. The table is referred to follow the applicable torque values.
B. The applicable torque values are used to obey the table.
C. See the table below for the applicable torque values.
A. The selection of data by manual producers which are included in this section shall be restrained by the
concepts contained in the preface of this specification,
B. The selection of data by manual producers included in this section shall be governed by the concepts
contained in the preamble to this specification.
C. In his selection, the producer's choice of data should be bound by concepts contained in the preamble of
this specification.
