A、 Make sure that the diameter of the hole is less than the specified value.
B、 Make sure that the diameter of the hole is more than the specified value.
C、 Make sure that the radius of the opening is less than the specified
value.
答案：A
A、 Make sure that the diameter of the hole is less than the specified value.
B、 Make sure that the diameter of the hole is more than the specified value.
C、 Make sure that the radius of the opening is less than the specified
value.
答案：A
A. INBOARD
B. OUTBOARD
C. ONBOARD
A. 无论是否经过书面许可,都不得以任何形式复制本文件的任何部分。
B. 经出版者书面许可,可以复制本文件的任何部分。
C. 未经出版者书面许可,不得以任何形式复制本文件的任何部分。
A. In flight,Flight Idle Power required for the engine to operate at slowly
speed is an important condition to ensure good engine operation and
airplane handing characteristics.
B. Flight Idle Power is the power required for an engine to operate at
a minimum speed during flight to ensure satisfactory engine operation and
aircraft handing characteristics.
C. In flight,good engine operation and aircraft handing characteristics
are guaranteed to provide the engine with Flight Idle Power needed to
operate at the lowest speed .
A. 其他信息可能会显示在封面上。
B. 其他信息可能会在盖板上留下。
C. 其他信息可能会显示在目录上。
A. ABC has determined the varied mission the airplanes performed, type
of care given, and age and utilization rates because providing additional
inspection requirement is prerequisite to further ensure that the
airplane can continue to carry the design loads it was initially certified
for based on inspections, tests, and analyses.
B. ABC has determined that providing additional inspection requirements
is prerequisite to further ensure that the airplanes can continue to carry
the design loads it was initially certified for based on inspections,
tests, and analyses because of the varied mission the airplanes performed,
type of care given, and age and utilization rates.
C. To further ensure that the airplanes can continue to carry the design
loads it was initially certified for, owing to the diversified mission
the airplanes performed, type of care given, and age and utilization rates,
A. Copy density should be the same throught the page.
B. Copy density must be different throught the page.
C. Density of copy must be different throught the page.
A. 文本应尽可能简单易懂。
B. 文本可以尽量简单易懂。
C. 文本应该尽可能简明扼要。
A. ALTITUDE
B. DECREASE
C. INCREASE
A. 如果轮胎温度升高超过 177 度,插头熔化且轮胎放气。
B. 如果轮胎温度升高超过 177 度,易熔塞和轮胎融化。
C. 如果轮胎温度升高超过 177 度,易熔塞熔化且轮胎放气。
A. 建立单独的导线标识码,以组建追踪电路(如图 5)
B. 建立单独的导线标识码,以协助追踪电路(如图 5)
C. 建立单独的导线标识码,以装配追踪电路(如图 5)
