A、 When you need to understand a schematic diagram,use arrows to indicate
flow orienting.
B、 Arrows shall be used to indicate flow ends when needed to understand
the schematic diagram.
C、 When need to comprehend the chart,you should use arrows point to the
direction.
答案:A
A、 When you need to understand a schematic diagram,use arrows to indicate
flow orienting.
B、 Arrows shall be used to indicate flow ends when needed to understand
the schematic diagram.
C、 When need to comprehend the chart,you should use arrows point to the
direction.
答案:A
A. 在发动机记录卡上填写记录
B. 在室温下填写发动机记录卡
C. 把温度写在发动机记录卡上。
A. 维修手册中准备某些章节的技术数据需要机身制造商和各种其它部件制造商
之间的共同贡献和密切协作。
B. 编写维修手册某些章节的技术资料时,需要机身制造商和各种其他部件制造
商之间的共同协作。
C. 机身制造商和各种其他部件制造商可以共同协作以完成维修手册,一些章节的
技术参数的编写工作。
A. 最小允许误差 5 毫米。
B. 最大允许误差 5 毫米。
C. 最大容差 5 毫米。
A. The basis for assuring an airplane remains airworthy and safe to operate
is to combine the manufacturer’s requirements with sound inspection and
maintenance practices.
B. To ensure airworthiness and safe operation of an airplane, it is
essential to follow the manufacturer’s instructions in the utilization
of airplane, and perform sound inspection and maintenance as well.
C. Airworthiness and safe operation are fundamental to aircraft
utilization as required by the manufacturer, so sound inspection and
maintenance practices are carried out.
A. As only approved limitations may be excluded in this Section,an
introductory statement to this effect shall be contained in a prefatory
note or the opening paragraph.
B. An introductory statement to this effect included in a prefatory note
or the opening paragraph,that only approved limitations may be included
in this Section.
C. Due to only approved limitations may be included in this Section,an
introductory statement to this effect shall be included in a prefatory
note or the opening paragraph.
A. 航道与跑道中心线对齐,下滑道与跑道出口成一定的角度。
B. 航道与跑道中心线对齐,下滑道与跑道入口成恒定的角度。
C. 航道与跑道中心线平行,下滑道与跑道出口成恒定的角度。
A. If the sleeve is incorrectly attached, adjust it.
B. If the sleeve is badly attached, adjust it.
C. If the sleeve is wrong attached,adjust it.
A. 本规范旨在为最初以 12500 磅或以下(或 5700 千克)最大起飞重量认证的所
有类型通用航空飞机提供手册编制指南。
B. 本规范的制定是为手册编写提供规范性制导,用于 12500 磅(或 5700 千克)
或以下最大起飞重量的所有类型飞机。
C. 本规范规定了以起始为 12500 磅或以下(或 5700 千克)最大起飞重量认证的
所有类型通用航空飞机提供手指编制指导。
A. 确保间隙在限制范围内。
B. 确保空间有限。
C. 确保空间是受限的。
A. Divide the follow wind component by the aircraft speed to get the
correction.