A、 更换磨损超标的组件。
B、 更换磨损达标的组件。
C、 修理磨损超标的组件。
答案:A
A、 更换磨损超标的组件。
B、 更换磨损达标的组件。
C、 修理磨损超标的组件。
答案:A
A. 安装部件后进行功能测试。
B. 进行功能测试后安装部件。
C. 在安装部件后将进行操作测试。
A. 在设计理论图时,必须有必要在使理论图易于说明的细节与易于阅读和理解
的必要简化直接做成选择。
B. 在设计简图时,可能需要在使简图一目了然所有细节和易于阅读和理解所需
要的简单基础之间做出让步。
C. 在设计示意图时,可能有必要在使示意图易于说明的必要细节与易于阅读和
理解的必要简化之间做出折衷。
A. 副翼回到中立位后,确保其与襟翼齐平。
B. 扰流板回到原位后,保证和襟翼对齐。
C. 在副翼返回中心之后,保证它们和襟翼相连。
A. The values must not be more than the approved differences.
B. The values must not exceed the allowable differences.
C. The values must not exceed the approved error.
A. 向前旋转手柄
B. 向后移动水平面
C. 向后移动手柄
A. Maneuvering Speed is the maximum speed what required of full uncommitted
aerodynamic control will not exceed the airplane.
B. Maneuvering Speed is the largest speed that the aerodynamic application
by the full available control will not cause the aircraft overexert.
C. Maneuvering Speed is the maximum speed at which application of full
available aerodynamic control will not overstress the airplane.
A. 定位器与跑道中心线对齐,下滑道与跑道出口成一定角度
B. 航道与跑道中心线对齐。下滑道与跑道入口成恒定角度。
C. 航道与跑道中心线平行,下滑道与跑道出口成恒定角度。
A. You may use alerts and cautions to emphasize some important places.
B. The important parts must be highlighted by using the warnings,cautions
and notes.
C. Warning,cautions and notes may be used to highlight or emphasize
important points.
A. 如果不能将针或校准销推入检查孔,则表示杆眼足够深。
B. 如果不能将针或检查销推入检查孔,则表示杆眼足够深。
C. 如果不能将针或类似物推入检查孔,则表示杆眼足够深。
A. BREATHE
B. RESPIRE\NGET INTO