A、 如果在测试过程中,流量指示器没有达到预定位置,则使用此备用程序。
B、 如果在测试结束后,流量指示器没有达到设定位置,则使用此附加程序。
C、 如果在测试结束后,流量指示器没有达到设定位置,则使用此备用程序。
答案:A
A、 如果在测试过程中,流量指示器没有达到预定位置,则使用此备用程序。
B、 如果在测试结束后,流量指示器没有达到设定位置,则使用此附加程序。
C、 如果在测试结束后,流量指示器没有达到设定位置,则使用此备用程序。
答案:A
A. 当飞机在地面时用来估计燃油量的辅助系统.
B. 当飞机在地面时用来计算燃油量的辅助系统.
C. 当飞机在地面时用来探测燃油量的辅助系统.
A. 当你安装天线,排列符号必须指向前方。
B. 当你安装天线,校准箭头必须指向前方。
C. 当你安装天线,校准点必须向前方。
A. If the sleeve is incorrectly attached, adjust it.
B. If the sleeve is badly attached, adjust it.
C. If the sleeve is wrong attached,adjust it.
A. server control unit
B. service control unit
C. servo control unit
A. 用螺母将面板固定在支架上
B. 用螺栓将面板连接到结构上
C. 用螺栓将面板固定在支架上
A. EAT
B. INGEST
C. SWALLOW
A. viation Regulations may prepare CAPs
B. General Aviation Manufacturers Association Built up this Specification
to guide the airplane, engine and component manufacturers to prepare
C. APs
D. ocuments(which may also be
called Continuing Airworthiness Programs or CAPs). All types of general
aviation airplanes and components certified under the applicable Federal
F. ederal
I. nspection Documents(which may also be
called Continuing Airworthiness Programs or CAPs). All types of general
aviation airplanes and components certified under the applicable Federal
A. GOES
B. LEAVES
C. GETS
A. Loosen and remove nut with wrench.
B. Tighten and torque nut with spanner.
C. Remove and replace nut with wrench.
A. The wire must touch the front of the contact.
B. The wire must bond the rear of the contact.
C. The wire must touch the rear of the contact.