736.LET THE VENT VALVES( ) OPEN.

A. 　Nomenclature shall be similar throughout all technical data obtained
to the Customer.

B. 　Nomenclature shall be consistent throughout all technical data provided
to the Customer.

C. 　Nomenclature must be similar throughout all technical data provided
to the Customer.

A. 　When you need to understand a schematic diagram,use arrows to indicate
flow orienting.

B. 　Arrows shall be used to indicate flow ends when needed to understand
the schematic diagram.

C. 　When need to comprehend the chart,you should use arrows point to the
direction.

A. 　ABC has determined the varied mission the airplanes performed, type of
care given, and age and utilization rates because providing additional
inspection requirement is prerequisite to further ensure that the
airplane can continue to carry the design loads it was initially certified
for based on inspections, tests, and analyses.

B. 　ABC has determined that providing additional inspection requirements
is prerequisite to further ensure that the airplanes can continue to carry
the design loads it was initially certified for based on inspections,
tests, and analyses because of the varied mission the airplanes performed,
type of care given, and age and utilization rates.

C. 　To further ensure that the airplanes can continue to carry the design
loads it was initially certified for, owing to the diversified mission
the airplanes performed, type of care given, and age and utilization rates,

A. 　does not permitted to

B. 　not permitted to do

C. 　permit to do

A. 　Pressurize the system to 150 bar with the hydraulic pump.

B. 　Pressurize the system to 150 bar with the hand pump.

C. 　Pressuring the system to 150 bar with the hand pump.

A. 　 PRODUCE

B. 　 GENERATE

C. 　 SUPPLY

A. 　Maneuvering Speed is the maximum speed what required of full uncommitted
aerodynamic control will not exceed the airplane.

B. 　Maneuvering Speed is the largest speed that the aerodynamic application
by the full available control will not cause the aircraft overexert.

C. 　Maneuvering Speed is the maximum speed at which application of full
available aerodynamic control will not overstress the airplane.

A. 　拆/装、拆卸/安装部分应清楚说明拆卸和安装部件或组件所需的步骤顺序,以
及遵循的预防事项。

B. 　拆装、拆卸/安装部分应清楚说明拆卸和重新安装部件或组件所需的步骤顺序,
以及要遵守的预防措施。

C. 　拆/装、拆卸/安装部分应清楚说明拆卸和重新安装部件或组件以及遵循的预防
事项所需的步骤顺序。

A. 　其他信息可能会显示在封面上。

B. 　其他信息可能会在盖板上留下。

C. 　其他信息可能会显示在目录上。

A. 　如果轮胎温度升高超过 177 度,插头熔化且轮胎放气。

B. 　如果轮胎温度升高超过 177 度,易熔塞和轮胎融化。

C. 　如果轮胎温度升高超过 177 度,易熔塞熔化且轮胎放气。