774.The use of the schematic diagram is the pilot.

A. 　GO INTO

B. 　CIRCULATE

C. 　FLOW

A. 　The wind speeds recorded as alterables on the diagrams of this Handbook
shall be understood as the headwind or tailwind components of the reported
wind .

B. 　The wind velocities recorded as variables on the charts of this Handbook
are goning to be understood as the headwind or tailwind constituents of
the reported wind .

C. 　The wind velocities recorded as immutables on the charts of this

A. 　Maneuvering Speed is the maximum speed what required of full uncommitted
aerodynamic control will not exceed the airplane.

B. 　Maneuvering Speed is the largest speed that the aerodynamic application
by the full available control will not cause the aircraft overexert.

C. 　Maneuvering Speed is the maximum speed at which application of full
available aerodynamic control will not overstress the airplane.

A. 　 Make sure that the diameter of the hole is less than the specified value.

B. 　 Make sure that the diameter of the hole is more than the specified value.

C. 　 Make sure that the radius of the opening is less than the specified
value.

A. 　 如果有编号,它们无需遵循本规范中的编号而按流程编号,为了避免因规范
材料不适用飞机构型而产生的“间隙”。

B. 　 如果有编号,它们无需遵循本规范中的编号而按特定的方法编号,以避免因
规范材料不符合飞机型号而产生的“差距”。

C. 　 如果有编号,它们应按顺序编号,无需遵循本规范中的编号,以避免因规范
内容不适用飞机型号而产生的“间隙”。

A. 　wash system

B. 　water system

C. 　cleaning system

A. 　Where schematic diagrams are complex by virtue of automatic features
or articulated controls in the subject system, these characteristics
should be pointed by means of explanatory text in the diagram, or in the
accompanying text,or both.

B. 　Where schematic diagrams are complex by venture of automatic characters
or articulated controls in the subject system, these characteristics
should be pointed at by means of apparent text in the diagram, or in the
accompanying text,or both.

C. 　Where schematic diagrams are complex by virtue of automatic features
or interrelated controls in the subject system, these characteristics
should be pointed out by means of explanatory text in the diagram, or in
the accompanying text,or both.

A. 　the lower seal comes into view when you pull the lower bearing down.

B. 　The lower seal shows as the lower bearing is pulled down.

C. 　The lower seal appears as the up bearing is pulled down.

A. 　the lower seal comes into view when you pull the lower bearing down.

B. 　The lower seal shows as the lower bearing is pulled down.

C. 　The lower seal appears as the up bearing is pulled down.

A. 　In favour of reading and cross occurrence, illustrations, figures and
chats should be presented in a vertical layout,if applicable.

B. 　Be convenient for reading and intercross performance,illustrations,
figures and diagrams should be presented in a vertical layout,if
pragmatic.

C. 　For ease of reading and cross reference, illustrations, figures and
tables should be presented in a vertical layout,if practical.