46.The torsion link assembly can transmit torsional loads from the axle
to the shock strut.

A. 　The manufacturers of major components must provide maintenance,
troubleshooting, inspection and repair data in the same layout of this
specification.

B. 　The manufacturers of major components is looking forward to gain
maintenance, troubleshooting, inspection and repair data with the same
form of this specification.

C. 　The manufacturers of major components should provide maintenance,
troubleshooting, inspection and repair data with same form of this
specification.

A. 　在伸缩管和缝翼输送管的开口端盖上堵盖。

B. 　在伸缩管和缝翼输送管的末端打开堵盖。

C. 　在防冰管和缝翼输送管的末端打开堵盖。

A. 　 Send the results of the audit to the quality department

B. 　 Tell the quality department about the results of the analysis

C. 　 Let the quality department know the results of audit

A. 　Copy density should be the same throughout the page.

B. 　Copy density must be different throughout the page.

C. 　Density of copy must be consistent throughout the page.

A. 　如果大型插图水平放置,索引批注和标题最好是径向放置。

B. 　尽管大型插图水平放置,索引批注和标题最好是垂直放置。

C. 　因为大型插图横向放置,索引批注和标题最好是垂直放置。

A. 　Apart from printing "This page intentionally blank" on blank pages,
the Document producer may use dual page numbering on pages preceding or
following a blank page.

B. 　Instead of printing "This page intentionally blank" on blank pages,
the Document producer may use dual page numbering on pages preceding or
following a blank page.

C. 　Except printing "This page intentionally blank" on blank pages. the

A. 　Pressurize the system to 150 bar with the hydraulic pump.

B. 　Pressurize the system to 150 bar with the hand pump.

C. 　Pressuring the system to 150 bar with the hand pump.

A. 　Loosen and remove nut with wrench.

B. 　Tighten and torque nut with spanner.

C. 　Remove and replace nut with wrench.

A. 　维修手册中某些章节的技术资料的编写,需要机身制造商和用于制造整架飞机
的各种其他部件的制造商共同奉献和密切计划。

B. 　维修手册中某些章节的技术资料的编写,需要机身制造商和整机其他各制造商
共同奉献和密切计划。

C. 　维修手册中某些章节的技术资料的编写,需要机身制造商和用于制造整机的各
种其他部件的制造商共同合作和密切协调。

A. 　Replace components that worn more than the maximum limits.

B. 　Replace components that worn more than the less than limits.

C. 　Replace components that worn more than the minimum limits.