57.Additionally,items not previously considered for inclusion in the CAP
may be uncovered through operator inspections.

A. 　The basis for assuring an airplane remains airworthy and safe to operate
is to combine the manufacturer’s requirements with sound inspection and
maintenance practices.

B. 　To ensure airworthiness and safe operation of an airplane, it is
essential to follow the manufacturer’s instructions in the utilization
of airplane, and perform sound inspection and maintenance as well.

C. 　Airworthiness
aircraft
utilization as required by the manufacturer, so sound inspection and
maintenance practices are carried out.

A. 　The wind speeds recorded as alterables on the diagrams of this Handbook
shall be understood as the headwind or tailwind components of the reported
wind .

B. 　The wind velocities recorded as variables on the charts of this Handbook
are goning to be understood as the headwind or tailwind constituents of
the reported wind .

C. 　The wind velocities recorded as immutables on the charts of this

A. 　Maneuvering Speed is the maximum speed what required of full uncommitted
aerodynamic control will not exceed the airplane.

B. 　Maneuvering Speed is the largest speed that the aerodynamic application
by the full available control will not cause the aircraft overexert.

C. 　Maneuvering Speed is the maximum speed at which application of full
available aerodynamic control will not overstress the airplane.

A. 　If the sleeve is incorrectly attached, adjust it.

B. 　If the sleeve is badly attached, adjust it.

C. 　If the sleeve is wrong attached,adjust it.

A. 　This material releases dangerous fumes when it touches hot surfaces.

B. 　On contact with hot surfaces, this material produces dangerous fumes.

C. 　This material happens dangerous gases when it comes into contact with
hot surfaces.

A. 　当反推放出时,所有的人员远离飞机。

B. 　当发动机工作时,所有的人员远离飞机。

C. 　当油门工作时,所有的人员远离飞机。

A. 　LIGHTS

B. 　COMES IN

C. 　COMES ON

A. 　Instead of using the actual date of issue on each page of an original
issue of a Handbook, the words "original issue" may be used.

B. 　The actual release date should not be used on each page of this
handbook.The term "Ahead release"Should instead be used.

C. 　In place of using the actual date of release on each page of an original
issue of a handbook,the letters"Original issue"Have to be used.

A. 　 Apart from printing "This page intentionally blank" on blank pages,
the Document producer may use dual page numbering on pages preceding or
following a blank page.

B. 　 Instead of printing "This page intentionally blank" on blank pages,
the Document producer may use dual page numbering on pages preceding or
following a blank page.

C. 　 Except printing "This page intentionally blank" on blank pages. the

A. 　Apply mass on the surface of the patch to ensure that the parts bond
correctly.

B. 　Bear down on the surface of the patch to make sure that the parts bond
correctly.

C. 　Apply weight on the surface of the patch to make sure that the parts
bond correctly.