105.THE OIL MUST ( ) OUT OF THE VALVE.

A. 　The Handbook shall include information concerning the procedures or
behaviors that need to be taken by the maintenance of the airplane to
maintain the Handbook in a current conditions.

B. 　The Handbook shall contain information concerning the procedures or
measures that need to be taken by the manufacturer of the airplane to hold
the Handbook in a current status.

C. 　The Handbook shall contain information concerning the procedures or
actions that need to be taken by the operator of the airplane to maintain
the Handbook in a current status.

A. 　真实空速是飞机相对于未受扰动的空气的空速,是根据高度、温度和压缩性
修正的 CAS。

B. 　真实空速是飞机相对于稳定的空气的空速,是根据姿态、温度和膨胀性修正
的 CAS。

C. 　真实空速是飞机相对于未受扰动的空气的空速,是根据高度、温度和调节性
修正的 CAS。

A. 　喷油孔故障会导致不正确的操作。

B. 　喷油孔堵塞会导致不正确的信息。

C. 　喷油孔堵塞会导致不正确的操作。

A. 　ambient Air Temperature is the static free air temperature attained
from inflight temperature indications or surface meteorological sources,
adjusted for instrument error and compressibility effects.

B. 　Outside Air Temperature is the free air electrostatic temperature,
contained neither from inflight temperature indications nor ground
meteorological and compressibility effects.

C. 　Outside Air Temperature is the free air static temperature, obtained
either from inflight temperature indications or ground meteorological
sources, adjusted for instrument error and compressibility effects.

A. 　一个燃油马达安装在区域 10

B. 　一个燃油马达在区域 10 运转

C. 　一个燃油泵安装在区域 10

A. 　 当你安装天线,排列符号必须指向前方。

B. 　 当你安装天线,校准箭头必须指向前方。

C. 　 当你安装天线,校准点必须向前方。

A. 　更换磨损超标的组件。

B. 　更换磨损达标的组件。

C. 　修理磨损超标的组件。

A. 　Both master schematic diagrams and system function of complex systems
should be for simplicity of presentation and understandability.

B. 　Complex systems should be divided into system function but not overall
master schematic diagrams for homeliness and a better understanding of
presentation.

C. 　For simplicity of presentation and understandability, complex systems
should be divided into either system function or overall master schematic
diagrams.

A. 　ACCESS

B. 　NEAR

C. 　CLOSE

A. 　Clean the surface to ensure there will be good adhesion.

B. 　Clean the surface to ensure firm adhesion.

C. 　Clean the surface to make sure that the bond is satisfactory.