169.If the adjustment of the stops is not correct, the results of the
test will not be accurate.

A. 　viation Regulations may prepare CAPs

B. 　General Aviation Manufacturers Association Built up this Specification
to guide the airplane, engine and component manufacturers to prepare

C. 　APs

D. 　ocuments(which may also be
called Continuing Airworthiness Programs or CAPs). All types of general
aviation airplanes and components certified under the applicable Federal

F. 　ederal

I. 　nspection Documents(which may also be
called Continuing Airworthiness Programs or CAPs). All types of general
aviation airplanes and components certified under the applicable Federal

A. 　irworthiness Programs prepared to enhance safety.

B. 　、Standardization will enhance safety though uniform interpretation of
inspection requirements contained in

C. 　、Standardization will in accord with this Specification through uniform
interpretation of inspection requirements contained in Continuing

A. 　、 A the inspection,repairs,preservation,etc. of item influenced by STCs in ABC
Manual or CAPs must be brought to the attention of the STC holder by the
owner or maintenance organization.

C. 　holder must be informed of all item affected by STCs in ABC
Manuals or CAPs by the owner or maintenance organization in order to gain

A. 　Divide the follow wind component by the aircraft speed to get the
correction.

B. 　Divide the crosswind component by the aircraft speed to get the
righting.

C. 　Divide the crosswind component by the aircraft speed to get the
correction.

A. 　GET DOWN

B. 　FALL TO

C. 　GO DOWN

A. 　GO INTO

B. 　SPILLS

C. 　FLOW

A. 　COLLECTS

B. 　ABSORBS

C. 　DRAWS

A. 　如果通气桅杆排气量不正常,做系统测试。

B. 　如果通气桅杆排气量非常多,做系统测试。

C. 　如果通气桅杆排气量非常少,做系统测试。

A. 　The manufacturers of major components must provide maintenance,
troubleshooting, inspection and repair data in the same layout of this
specification.

B. 　The manufacturers of major components is looking forward to gain
maintenance, troubleshooting, inspection and repair data with the same
form of this specification.

C. 　The manufacturers of major components should provide maintenance,
troubleshooting, inspection and repair data with same form of this
specification.

A. 　When you need to understand a schematic diagram,use arrows to indicate
flow orienting.

B. 　Arrows shall be used to indicate flow ends when needed to understand
the schematic diagram.

C. 　When need to comprehend the chart,you should use arrows point to the
direction.