A、 Make sure that the diameter of the hole is less than the specified value.
B、 Make sure that the diameter of the hole is more than the specified value.
C、 Make sure that the radius of the opening is less than the specified
value.
答案:A
A、 Make sure that the diameter of the hole is less than the specified value.
B、 Make sure that the diameter of the hole is more than the specified value.
C、 Make sure that the radius of the opening is less than the specified
value.
答案:A
A. The wire must touch the front of the contact.
B. The wire must bond the rear of the contact.
C. The wire must touch the rear of the contact.
A. GO INTO
B. SPILLS
C. FLOW
A. 如果有编号,它们无需遵循本规范中的编号而按流程编号,为了避免因规范
材料不适用飞机构型而产生的“间隙”。
B. 如果有编号,它们无需遵循本规范中的编号而按特定的方法编号,以避免因
规范材料不符合飞机型号而产生的“差距”。
C. 如果有编号,它们应按顺序编号,无需遵循本规范中的编号,以避免因规范
内容不适用飞机型号而产生的“间隙”。
A. 发动机的驱动马达没有点火。
B. 启动发动机但不点火。
C. 带转发动机但不点火。
A. 在活塞发动机驱动的飞机上,排气温度指示器用于识别各种功率设置下的油
气比。
B. 在活塞发动机驱动的飞机上,排气温度指示器用于设置各种功率设置下的油
和空气的混合比。
C. 在动力活塞驱动的飞机发动机上,排气温度指针用于识别最大功率设置下的
油气比。
A. 型号合格证
B. 类型合格证
C. 型号许可证
A. Divide the follow wind component by the aircraft speed to get the
correction.
A. 制造商决定将封面上的信息标示在左侧。
B. 制造商将封面信息做为指引在左侧列出。
C. 封面上包含的信息将由制造商自行决定。
A. The system interconnect circuits adapt to the physical properties of
the connected systems.
B. The system interface circuits adapt to the physical protections of the
connected systems.
C. The system interface circuits adapt to the physical properties of the
connected systems.
A. 控制单元安装在驾驶室后部。
B. 控制组件安装在驾驶舱的后部。
C. 控制组件安装在飞行舱之后。