A、 In this section which is a separate attachment of the Handbook or as
a separate document, the manufacturer shall provide an equipment list.
B、 The manufacturer shall provide an equipment list in this section, in
a separate document appended to the Handbook, or as a separate document.
C、 Being a separate appendix of the Handbook or as a separate document,
the manufacturer shall provide a list of equipment of this section.
答案:B
A、 In this section which is a separate attachment of the Handbook or as
a separate document, the manufacturer shall provide an equipment list.
B、 The manufacturer shall provide an equipment list in this section, in
a separate document appended to the Handbook, or as a separate document.
C、 Being a separate appendix of the Handbook or as a separate document,
the manufacturer shall provide a list of equipment of this section.
答案:B
A. Nomenclature shall be similar throughout all technical data obtained
to the Customer.
B. Nomenclature shall be consistent throughout all technical data provided
to the Customer.
C. Nomenclature must be similar throughout all technical data provided
to the Customer.
A. All flow control devices within the system, such as check valves, fuel
pumps, accumulators, and relays should be included.
B. All flue control devices within the system, such as single valves, fuel
pumps, storage, and relays should be included.
C. All flow control devices within the system, such as single valves, fuel
pumps, accumulators, and relays should be included.
A. You do not need to given the return processes in its entirely unless
you need to comprehend the system.
B. Unless you need to understand the system,do not need be shown full the
return lines.
C. Return procedures need not be shown in completely besides needed to
realize the system.
A. 将分隔标签平行放置,并用节号或标题或两者一起标记。
B. 将分隔标签错开,并用节号或标题或两者一起标记。
C. 将分隔标签顺序放置,并用节号或标题或两者一起标记。
A. To include a relocated chapter table of contents is not required if
the total chapter has been relocated, while the subsystem relocations
should then be identified in the Table of Contents at the front of the
book.
B. On conditional that the total chapter has been relocated, to include
a relocated chapter table of contents is not important,then the subsystem
relocations should then be identified in the Table of Contents at the front
of the book.
C. If the total chapter has been relocated, it is not forced to contain
a relocated chapter table of contents, and the subsystem relocations
should then be identified in the Table of Contents at the front of the
book.
A. 这个手册需要花费两个小时读完。
B. 做这个程序需要两个小时。
C. 两个小时必须完成这个程序。
A. You may use alerts and cautions to emphasize some important places.
B. The important parts must be highlighted by using the warnings,cautions
and notes.
C. Warning,cautions and notes may be used to highlight or emphasize
important points.
A. The CAP will come up with main and subordinate airframe components,
and main and subordinate systems to achieve the stated objective of
continued airworthiness.
B. Primary and secondary airframe components, and Primary and secondary
systems are contained in CAP to complete the stated objective of continued
airworthiness.
C. To continue the stated objective of sustain airworthiness, major and
minor airframe components, and major and minor system are covered in CAP.
A. 当反推放出时,所有的人员远离飞机。
B. 当发动机工作时,所有的人员远离飞机。
C. 当油门工作时,所有的人员远离飞机。
A. 主题标题应与本规范中使用的示例相同,或实质上等同于本规范中使用的示
例,除非因飞机型号的设计或运行特点而不适用。
B. 除了因飞机种类的设计或操作方式不适用的情况,主题标题应与本规范中使
用的示例一致或本质相似。
C. 除了因飞机类型的设计或运行方式不适用的情况,主题标题应与本规范中使
用的示例一致或近似。