A、 Nothing will happen during retraction if the upper drag strut is replaced correctly.
B、 lf you install the upper drag strut by mistake, it will break the lower drag strut during extension.
C、 Wrong installation of the upper drag strut will cause the hitting of the lower drag strut during retraction.
答案：C
A、 Nothing will happen during retraction if the upper drag strut is replaced correctly.
B、 lf you install the upper drag strut by mistake, it will break the lower drag strut during extension.
C、 Wrong installation of the upper drag strut will cause the hitting of the lower drag strut during retraction.
答案：C
A. 连接可以连接的导线
B. 把断开的导线重新断开
C. 连接断开的导线
A. 拆除部件之前,给系统充气
B. 安装部件之前,给系统释压
C. 断开部件之前,给系统放气
A. illustrations should be used when they will simplify, shorten or make the text easier to understand.
B. When illustrations can simple, shorten or r make the text easy for understanding, they may be used.
C. Whenever diagram is can simple, shorten or make the understand, they could be used.
A. 确保厕所组件正确冲洗。
B. 确保厕所马桶正常工作。
C. 确保厨房组件正常工作。
A. Move the hose to make sure that the inner connection
B. Move the tube to ensure that the inner connection is loosen.
C. Move the tube to make sure that the inner connection is tight.
A. 在向系统中注入新滑油之前,强制性重置油滤。
B. 在向系统中注入新滑油之前,必须更换油滤。
C. 在系统中注入新滑油之前,建议更换过滤器。
A. The Specification provides flexibility in Handbook preparation based on the complexity of the airplane
while maintaining a high degree of standardization of arrangement, definitions, and performance
information.
B. The Specification provides flexibility in Handbook preparation based on the complicacy of the airplane, but
ignoring a high degree of standardization of structure, definitions, and performance information.
C. The Specification provides uniformity in Handbook preparation based on the simplicity of the airplane
while retaining a high degree of standardization arrangement, definitions; and performance information.
A. According to the authority given to persons specified below, the unit recognized in item 3 was inspected
in the manner stipulated by authority and is approved.
B. Based on the authority given to the following stated persons, the unit described in item 3 was inspected in
the authority defined manner and gets approved.
C. Thanks to the authority given to persons as below, the unit found in item 3 was inspected in the manner
stipulated by authority which is approved.
A. The condition lever is the primary control for start and stop the engine
B. The condition lever is the minor control for starting and stopping the engine.
C. The condition lever is the primary control for starting and stopping the engine.
A. Lubricate one side of the washers.
B. Lubricate one side of the seals.
C. Wash one side of the washers.
