A、 确保 P36 面板上的“交流已连接”及“未使用”指示灯点亮。
B、 确保交流电已连接,并且 P36 面板上的“未使用”指示灯处于点亮状态
C、 确保 P36 面板上的“交流已连接指示灯点亮,但其并末使用
答案：A
A、 确保 P36 面板上的“交流已连接”及“未使用”指示灯点亮。
B、 确保交流电已连接,并且 P36 面板上的“未使用”指示灯处于点亮状态
C、 确保 P36 面板上的“交流已连接指示灯点亮,但其并末使用
答案：A
A. This system is used to expand and return the landing gear
B. This system is used to extend and retract the landing gear.
C. This system is used to extract and retract the landing gear.
A. 警告和告诫应置于其适用的文本前,但注释则可以根据需强调的内容置于相应文本前或文本后。
B. 警告和告诫应置于其适用的文本后,但注释则可以根据显示的材料内容置于文本前或文本后。
C. 警告和告诫应置于其适用的文本上方,但注释则可以根据需要强调的文本内容置于其上方或下方。
A. Install two mats, each 3.5 mm thick.
B. Install two spacers, each 3.5 mm thick.
C. Install two rings, each 3.5 mm thick.
A. 用于密封油箱的所有材料对所有燃油和燃油稳定剂都耐用。
B. 用于密封油箱的所有材料对所有燃油和燃油添加剂都耐用。
C. A 用于密封油箱的所有材料对所有燃油和燃油添加剂都防水。
A. This program describes how to identify an immediate failure and how to handle a malfunction occurred.
B. This procedure explains how to recognize impending problems and what to do if malfunctions occur.
C. How to confirm the current problems and what should you do when malfunctions occur are described in
this procedure.
A. Chromate is added into the primer to protect corrosion
B. A material that protects the primer from corrosion in contained in it.
C. There is corrosion-preventive material in the primer.
A. When the temperature is below zero, depressurize the water system.
B. If the temperature drops below zero, deflate the water system.
C. If the temperature decreases to less than zero, drain the water system.
A. If as many as 50% of the holes are contaminated, you should clean the display units behinds the holes.
B. The holes on the bottom of the display unit should be cleaned once over 50% of them are clogged due to
contamination.
C. If contamination causes a blockage of more than 50 percent of the holes, then clean the holes on the rear
of the display units.
A. 操作部件两个循环,从管道排除空气,拆下组件
B. 操作部件两个循环,排除管道中的空气
C. 操作部件使空气两次循环,从管子上拆下
A. Where a low flow or undercooling condition occurs, the low flow sensor sends an alarm signal to the flight
compartment for warning.
B. When a low flow or not sufficient cooling condition occurs, the low flow sensor supplies an alarm signal to
the flight compartment for annunciation.
C. When a low flow or insufficient cooling condition occurs, the low flow sensor applies a alarm signal to the
flight compartment for caution
