A、 Uncontrolled system or old equipment cause hydraulic fluid flow from hydraulic system A to B.
B、 If you fail to operate the system control properly or the equipment is damaged, the hydraulic fluid will be transferred between hydraulic system A and B.
答案：B
A、 Uncontrolled system or old equipment cause hydraulic fluid flow from hydraulic system A to B.
B、 If you fail to operate the system control properly or the equipment is damaged, the hydraulic fluid will be transferred between hydraulic system A and B.
答案：B
A. The center of gravity moves along with the weight of the wings.
B. The center of gravity moves in relation to forces applied on the wings.
C. The center of gravity moves evenly to the 1oads of the wings.
A. Make sure that you quarantine the removed insulation material.
B. Make sure that you recycle the removed insulation material.
C. Make sure that you quarantine the removed composite material.
A. The function and operation of each unit in the system should be described. The location of the units
shouldn’t' be described.
B. The function, operation and location of each unit in the system should be deleted.
C. The function, operation and location of each unit in the system should be described. (描述)
A. 这些 ALIs 是强制性的,未经负责飞机型号证书的 CFAA 办公室或适用的监管机构的批准,不能更改或删
除。
B. 这些 ALls 是指令性的,未经 FAA 办公室批准不得更改或删除。FAA 办公室负责飞机型号证书,或发布适
用的管理规章。
C. 这些 ALls 是非常必要的,任何更改或删除必须获得 FAA 办公室批准,或者其他可以颁发飞机型号证书的
监管机构的批准
A. Make sure that material and dimensions of the new floor panel are the same with the removed one.
B. Make sure that contour and design the new floor panel have no difference with the removed one.
C. Make sure that the new floor panel has the same contour and dimensions as the removed floor panel.
A. Schematics must be readable to a normal visioned person, so legends, symbols devices, codes, etc.
,
should be of sufficient size. The schematic diagram should be designed to turn over the page when the
content is necessary.
B. The schematic diagram must be of sufficient size that legends, symbols, devices, codes etc., are readable by
persons with normal vision. Turn-page schematic diagram shall be avoided to the extent practical.
C. The schematics symbols, devices, codes etc. must be 1egib1e, so peop1ewith normal vision should avoid
turning the schematic pages as much as possible
A. An annunciator device is displayed on the panel, which shows how it works.
B. If an annunciator panel is installed, explain how it operates.
C. lf a display appears on the annunciator panel; it explains that how the system works.
A. All publications shall use the standard numbering system.
B. All documents and materials shall use the standardized numbering index system
C. All publications shall use the standard numbering system for indexing.
A. If as many as 50% of the holes are contaminated, you should clean the display units behinds the holes.
B. The holes on the bottom of the display unit should be cleaned once over 50% of them are clogged due to
contamination.
C. If contamination causes a blockage of more than 50 percent of the holes, then clean the holes on the rear
of the display units.
A. Setting cable tension, flight control surfaces travel limits and stops are the main tasks of rigging.
B. Cable tension set, flight controls travel limits adjustment and travel stops set are the rigging procedures.
