866、Continuing Airworthiness Program Inspections usually consist of two pages one text page and one
illustration page.

A. 　 确保 P36 面板上的“交流已连接”及“未使用”指示灯点亮。

B. 　确保交流电已连接,并且 P36 面板上的“未使用”指示灯处于点亮状态

C. 　确保 P36 面板上的“交流已连接指示灯点亮,但其并末使用

A. 　 If there is hum from the loudspeaker, don’t adjust the potentiometer

B. 　 Adjust then potentiometer unless hear a hum from the loudspeaker

C. 　 Adjust the potentiometer until the loudspeaker no longer hums.

A. 　 The dictionary includes some unapproved words that can be technical names if you can put them in the
applicable technical name category.

B. 　 Some approved words are included in the dictionary, they. can be technical names if they belong to
applicable technical name category.

C. 　 The dictionary contains some unapproved words, which can be put, in separate technical name category,
they can be technical names.

A. 　 The drain float valves in the vent tubes and the vent channels dilute the fuel in the vent system to drain
out of the tank when the fuel face is lower than the valve.

B. 　 The drain float valves in the vent tubes and the vent channels permit fuel in the vent system to drain into
the tank when the fuel level is lower than the valve.

C. 　 The drain float valves in the vent tubes and from the vent channels allow the fuel in the vent system to
drain into the tank when the fuel quantity is lower than the valve.

A. 　这些 ALIs 是强制性的,未经负责飞机型号证书的 CFAA 办公室或适用的监管机构的批准,不能更改或删
除。

B. 　这些 ALls 是指令性的,未经 FAA 办公室批准不得更改或删除。FAA 办公室负责飞机型号证书,或发布适
用的管理规章。

C. 　这些 ALls 是非常必要的,任何更改或删除必须获得 FAA 办公室批准,或者其他可以颁发飞机型号证书的
监管机构的批准

A. 　 When cleaning corrosion with a cleaning fluid, avoid damaging adjacent areas.

B. 　 Avoid damaging the area around when we clean the corrosion with cleaner

C. 　 Use solution to clean the corroded area and prevent to damage the surroundings.

A. 　 Be sure that the position of the clamp has the same opinion with your record before you remove it

B. 　 Make sure that the position of the clamp is the same as the position you recorded during the removal
procedure

C. 　 Insure that the clamp matches the position that you recorded during the repair procedure.

A. 　 Tighten the bolts manually until you can do it with the specified tool.

B. 　 Tighten the bolts manually if it is not feasible to doit with the specified tool.

C. 　 In case that you cannot do it with the specified tool in case, tighten the bolts manually.

A. 　Make sure that there is supplied air flow in the work area.

A. 　确保副翼向下运动。

B. 　使方向舵移动更慢些。

C. 　确保升降舵移动缓慢。