1049 、 Those instructions necessary to support the aircraft during maintenance and repair includes
information on shoring materials and equipment, contour dimensions, shoring locations,

A. 　凹坑没有伤及保护漆层。

B. 　划痕没有穿透保护层。

C. 　划痕没有贯穿保护膜。

A. 　 It it very difficult to determine the effects of corrosion but as the reports from the CAP inspections are
received, the inspection times will be adjusted for any severe problems.

B. 　 It is not easy to decide the affection of corrosion,when the reports from the CAP inspections are received,
the inspection duration will be changed for any serious problems.

C. 　It is very hard to make the decision of the corrosion effects but if the reports from the CAP inspections are
obtained the inspection times will be arranged in accordance with the severest problem.

A. 　将卡箍放在电缆上以将其固定到位。

B. 　将线圈放在导线上以将其固定到位、

C. 　将线圈放在电缆上以将其固定到位。

A. 　保持安静以避免错过信号的声音。

B. 　保持安静以避免混淆声音的信号

C. 　保持安静以避免丢失声音信号。

A. 　 Utilize an oil-free solution.

B. 　 Use a solution with oil.

C. 　 The oil is not used that contains a solution.

A. 　 Install packing and support rings on bearing Glide bearing into cylinder until it is bottomed.

B. 　 Install packing and backward rings on bearing. Slash bearing into cylinder until the bottom is visible

C. 　 Install packing and alternative rings on bearing. Skid bearing into cylinder until you see the bottom.

A. 　 To make sure that ATC transceivers are in standby mode, you must simulate altitude, otherwise false TCAS
signals may occur intermittently.

B. 　 Make sure the ATC transmitters are in standby mode, or false TCAS targets may occur accidentally due to
altitude simulation.

C. 　 Make sure that the ATC transponders are in standby mode when you simulate altitude. You can
accidentally cause false TCAS targets.

A. 　lf you find metal particles in the reservoir find their source and repair the broken part.

B. 　 lf you find metal particles in the pump find their source and repair the defective part.

C. 　If you find material particles in the pump, find their source and repair the damaged part.

A. 　拧紧堵头至 6 牛顿

B. 　给堵头磅力矩至 6 牛米。

C. 　测量堵头紧力为 6 牛顿米。

A. 　 The forward and aft edges of the windshield has limits, otherwise the bottom and the top edge has not
limits.

B. 　 Because of the visibility of the bottom edge of the windshield and the top edge having the bus bar in the
way, the forward and aft edges of the windshield will be limited.

C. 　 This will be limited to the forward and aft edges of the windshield because of the bottom edge invisible
and the top edge having the bus bar in the way.