A、 Do not reach this speed with a given flap setting.
B、 Do not exceed this speed with a give flap setting.
C、 Do not exceed this speed with a given flap setting.
答案:C
A、 Do not reach this speed with a given flap setting.
B、 Do not exceed this speed with a give flap setting.
C、 Do not exceed this speed with a given flap setting.
答案:C
A. Make sure that the fuel quantity from the wing tanks to the center tank is the same.
B. Make sure that fuel from the wing tanks flows at the same rate into the center tank.
C. Make sure that the fuel flow supplied to the wing tanks and the center tank is at the same rate.
A. When the temperature is below zero, depressurize the water system.
B. If the temperature drops below zero, deflate the water system.
C. If the temperature decreases to less than zero, drain the water system.
A. 当必须理解原理图时,最好使用箭头来画出流动方向
A. 本文件中的任何零件没有出版商的许可不得复制
B. 本文件中没有任何一个部分是没有得到出版商书面许可的
C. 未经出版商书面许可,本文件任何部分不得以任何形式复制
A. The shim is t, which is thick by calculating x and y.
B. Calculate the shim, the result of the thickness is x-y.
C. The thickness of the shim is thus calculated、 t=x-y
A. Make sure that there is supplied air flow in the work area.
B. Make sure that there is sufficient airflow in the work area.
C. Make sure that there is efficient airflow in the work area.
A. 确保撑杆轮与滑道上的凸槽对齐
B. 确保转向架滚轮与轨道上的凹槽对齐。
C. 确保支架凸轮与滑轨上的滑块对齐。
A. The emergency exit doors are known as, backup exit and they should not be used in special condition
B. The emergency exit doors are used for the escape and are not used as the normal exits.
C. The emergency exit doors are applied to board that are not usually used for exit.
A. 距离皮托管中心线半径 3 英寸的修复表面轮廓外形,误差不应大于 0.007 英寸。
B. 距离静压盘中心线 3 英寸半径上的修复表面等高线,误差不应大于 0.007 英寸。
C. 静压孔中心线 3 英寸半径内的修复表面轮廓,误差不应大于 0.007 英寸。
A. 接通断路器。
B. 打开电路接头。
C. 拔出跳开关。