A、 There are remarks directly below the maintenance/overhaul section, extended from left to the right side
B、 You can find the comments which extends from left to right margins in the repair/modification section
below.
C、 The comments extended from right to left margins are located in the repair/alternation section.
答案：B
A、 There are remarks directly below the maintenance/overhaul section, extended from left to the right side
B、 You can find the comments which extends from left to right margins in the repair/modification section
below.
C、 The comments extended from right to left margins are located in the repair/alternation section.
答案：B
A. 门是用碳纤维增强塑料制作的。
B. 门是用防火纤维增强塑料制作的。
c、门是用化学纤维增强塑料制作的。
A. “维护操作”包括维修 拆卸/安装、调整/测试检测/检查、清洁/喷漆和批准的维修,应遵循故障排除部分
B. “维护操作“包括维修、拆卸/安装、调整/测试检测/检查、清洁/喷漆和正当的维修,,应遵循故障排除部分
C. “维护操作”包括维修、拆卸/安装、调整/测试检测/检查、铲除/喷漆和批准的维修,应遵循故障排除部分
A. The condition of the radome is very important for its performance.
B. The condition of the antenna influences its properties greatly.
C. The condition of the radar has an important effect on its characteristics.
A. Fuel leaks can decrease engine performance.
B. Oil leaks can increase engine performance.
C. Fluid leaks can decease engine efficiency
A. 这个程序包括拆卸恒速驱动装置(CSD)的说明。
D. )的指令。
A. To open the containers for these materials, sittable tools must be used.
B. The appropriate tools should be selected to open the materials; the containers is inside the materials.
C. The inappropriate tools should be selected to open the containers; the containers is made in the materials.
A. Removing it with special material is necessary if you find corrosion.
B. If you find corrosion, remove it with the specified material
C. lf corrosion is found, change the material to remove it.
A. Install packing and support rings on bearing Glide bearing into cylinder until it is bottomed.
B. Install packing and backward rings on bearing. Slash bearing into cylinder until the bottom is visible
C. Install packing and alternative rings on bearing. Skid bearing into cylinder until you see the bottom.
A. Maximum altitude loss during stall recovery is approximately 800 feet.
B. Maximum altimeter loss during spin recovery is about 800 feet.
C. Maximum weight loss during stall recovery is nearly 800 feet.
A. When the movement of input rod is ranged from 5 to10 mm, measure the piston retraction.
B. 4 When the input lever is between 5 and 10 mm, measure the piston extension.
C. When the interval of input shaft changes between 5 and 10 mm, measure the expansion of the piston.
