1136、Flight compartment is the compartment above the floor and between the forward
passenger partition and the forward pressure dome.

A. 　 make sure that the flaps and the slats are retracted

B. 　 make sure that the slats and the ailerons are retracted

C. 　 make sure that the flaps and the elevators are extended

A. 　 In designing schematic diagrams, it may be necessary to combine two aspects、 specification necessary to make the diagram clear, And the simplicity essential for ease of reading and understanding.

B. 　 In designing schematic diagrams, it may be necessary to comprehend two aspects、 detection necessary to make the diagram self-contained, And the simplification essential for ease of reading and understanding.

C. 　 In designing schematic diagrams, it may be necessary to compromise two aspects、 detail necessary to make the diagram self-explanatory、 And the simplicity essential for ease of reading and understanding

A. 　 On each page of an original document,the words "original issue”, rather than the actual date of issue, may
be used. Used the title page and the table of contents page before each section of the file must be marked
with the actual release date after the "original release."

B. 　AOn each page of an original documents, the words "original issue “maybe used. The actual release date is
in the file and must be standard on the title page and the table of contents page before each section.

C. 　 The actual issue date should be marked on each page of the original document. An alternative might be
to use the term "original issue" instead. To do so, the title page of the document and the table of contents
page at the beginning of each chapter must be marked "original publication.

A. 　 An "Airplane Weighing Form" shall be included in each handbook and the form shall contain an airplane
side view that shows the location of weighing points (using jacking points or landing gear) relative to the
datum line.

B. 　 Each handbook shall provide an aircraft side view that is included in an "Airplane Weighing Form" to show
the position of weighing points (using jacking points or landing gear) related to the datum line.

C. 　 An airplane three view that shows the weighing point)(using jacking points or undercarriage) relative to
the datum line shall be excluded in an "Airplane Weighing Form" of each handbook.

A. 　 For normal operations, make sure the pressure relief valve is closed. An open pressure relief valve is a
symptom of a problem in the fuel vent system.

B. 　 For normal operations, make sure the shut off relief valve works; lf you open pressure relief valve, that
indicates a problem in the fuel vent system.

C. 　 For normal operations, make sure you close the pressure relief valve. lf you leave it open a problem will be
shown in the fuel vent system.

A. 　 This program describes how to identify an immediate failure and how to handle a malfunction occurred.

B. 　 This procedure explains how to recognize impending problems and what to do if malfunctions occur.

C. 　 How to confirm the current problems and what should you do when malfunctions occur are described in
this procedure.

A. 　安装指示器时将其向后方倾斜。

B. 　为了安装指示器,应将其向后移动。

C. 　安装指示器时将其向前移动。

A. 　如何识别这些故障,排故信息以及这些故障的补救措施应该提供

B. 　 此规章应提供可能故障的排故信息,以及对这些故障的补救措施

C. 　应提供描述可能故障的排故信息,如何识别这些故障,以及针对那些故障的纠正措施

A. 　 Words with lowercase letters are allowed in STE.

B. 　 STE dictionary is permitted to use the UPPERCASE letter word.

C. 　 In STE, a word in capital letters means that it is approved.

A. 　 By using the basic provisions of FAR 21.50, revisions become consistent with the format of the
specification.

B. 　 FAR21.50 provisions are the basic to the revisions which are consistent with the format of the specification.

C. 　 To make reservations consistent with the format of the specifications, the provisions of FAR21.50 should
be adopted as a basis.