A、 Two controversial ways can be chosen to do the test, either with the Central Maintenance Computer
System through a0 the MCDU like you have probably learned already,and with a test switch on the VOR
receiver in the avionics compartment.
B、 You can do the test following procedures、 with the Central Maintenance Computer system by the MCDU,
you have probably learned already, and with a test switch on the VOR receiver in the avionics compartment.
C、 The test can be done in either way below、 using the Central Maintenance Computer System via the MCDU,
as you have probably already learned, or using a test switch on the VOR receiver in the avionics
compartment.
答案：C
A、 Two controversial ways can be chosen to do the test, either with the Central Maintenance Computer
System through a0 the MCDU like you have probably learned already,and with a test switch on the VOR
receiver in the avionics compartment.
B、 You can do the test following procedures、 with the Central Maintenance Computer system by the MCDU,
you have probably learned already, and with a test switch on the VOR receiver in the avionics compartment.
C、 The test can be done in either way below、 using the Central Maintenance Computer System via the MCDU,
as you have probably already learned, or using a test switch on the VOR receiver in the avionics
compartment.
答案：C
A. STE 是一种活的语言,需要用户的反馈来不断改进。
B. STE 是一种生活的语言,需要用户的培育来不断验证。
C. STE 是一种活的语言,需要用户的输入来不断应用。
A. Do not make the pressure became less than (or more than)20 psi.
B. Do not let the pressure become less than (or more than)20 psi.
C. Do not let the pressure close less than (or more than) 20 psi.
A. 停止测试 2 秒钟
B. 2 秒后启动测试
C. 2 秒后终止测试
A. The procedures should give the address of the facility and time the program will be rechecked to find out if it is coherent enough for the type of maintenance being performed at the facility.
B. The program shall be checked to decide if it is updated and sufficient for the type of maintenance being performed at the facility. The interval of the checks shall be stated in this procedure
C. The program will not be performed at the facility if this procedure shows outdated and inadequacy information for the the type of maintenance.
A. When the cross-feed system is open, it is possible for one fuel pump to supply fuel to the two engines.
B. When the supplying system is open, it is possible for one fuel pump to supply fuel to the two engines.
C. One fuel pump can supply fuel to two engines, as the supplying system is open.
A. When hydraulic system B engine drive pump pressure is under normal conditions, the hydraulic power
transfer unit system supplies standby hydraulic pressure to the leading edge flaps and slats.
B. The hydraulic power transfer unit system is provide spare hydraulic pressure to the leading edge flaps and
slats when hydraulic system B engine-driven pump pressure is abnormal.
C. The hydraulic power transfer unit system supplies alternate hydraulic pressure to the leading edge flaps
and slats when hydraulic system B engine-driven pump pressure is below normal
A. 正常俯仰控制法则基本上是负载系数的闭环控制,包括飞行发展保护。
B. 正常俯仰控制法基本上是负载厂家的闭环控制,包括飞行包线保护。
C. 正常俯仰控制法则基本上是负载系数的闭环控制,包括飞行包线保护。
A. 如果在平时使用中,大家更爱使用全称的话,其缩写也应标注在标题的括号内。
B. 如果在习惯用法中,相对于全称更倾向使用缩写的话,则该缩写也应包括在标题的括号内。
C. 应该将缩写包含在标题的括号内,如果平常更喜欢使用缩写而不是全称的话。
A. 将 O 形环安装在锥形轴承的内部凹槽中
B. 将 O 形环安装在圆柱形轴承的内部凹槽中
C. 将 O 形环安装在球形轴承的内部凹槽中
A. To list repair or modification orders, reference may be made to other document's repair standards or the
definition of special repair or modification elsewhere (e.g. Service kits, service notices, etc.).
B. Listing the repair or modification direct ions may contrast to the repair rules of another document or
lf liquids are spilled inside the galley, you must remove all signs of liquid and fully dry the areas of
especial repairs or modifications defined elsewhere (e.g., service kits, service annunciations, etc.).
C. Set forth repair or modification instructions and may refer to a standard repair in another document or a
special repair or modification defined elsewhere. such as in a service kit, service bulletin, etc.
