A、 If you do not find damage during the inspection Procedure, disassemble the unit.
B、 If you find damage during the inspect ion procedure, don't assemble the unit.
C、 If you find damage during the inspection procedure, disassemble the unit.
答案:B
A、 If you do not find damage during the inspection Procedure, disassemble the unit.
B、 If you find damage during the inspect ion procedure, don't assemble the unit.
C、 If you find damage during the inspection procedure, disassemble the unit.
答案:B
A. 不同的设计和复杂的型号使得飞机有一个重大的作用来决定特殊的失效是否更适合列举为“紧急”或“正常”程序。
B. 飞机的不同型号和机型的设计差异和复杂性,在决定某一特定故障是否更适合列为“紧急”程序或“异常”程序上发挥了重要的作用。
C. 各种型号的飞机的复杂设计差异很大程度能够决定特定失效是否能够更方便地列入“加急”或“反常”程序。
A. 以30度的幅度顺时针旋转调节器。
B. 以每次30度的增量,逆时针旋转调节器。
C. 逆时针旋转调节器,每次递减30度。
A. 飞行员呼叫开关位于 P19外部电源面板上。该面板位于飞机右侧的前轮上方。
B. 飞行员呼叫开关位于 P19外部电源面板上。该面板位于飞机右侧的前轮舱前方。
C. 飞行员呼叫开关位于 P19表面电源面板上。该面板位于飞机右侧的前轮上方。
A. The word given in the approved examples is not controlled.
B. The word given in the approved examples is not mandatory.
C. The word given in the approved examples is not a must.
A. It is necessary to generally check these areas.
B. It is imperative to regularly inspect these areas.
C. Frequent inspection of these areas is necessary.
A. STAY
B. STILL
C. LEAVE
A. 保留勤务部件,更换那些损坏的
B. 报废损坏的部件后,保留所有可用的。
C. 保留所有可用的部件,报废那些损坏的。
A. According to the authority given to persons specified below, the unit recognized in item 3 was inspected in the manner stipulated by authority and is approved.
B. Based on the authority given to the following stated persons, the unit described in item 3 was inspected in the authority defined manner and gets approved.
C. Thanks to the authority given to persons as below, the unit found in item 3 was inspected in the manner stipulated by authority which is approved.
A. If the pressure decreases quickly, the shear pins in the latch will break.
B. If the pressure reduces gradually, the shear pins in the lock will break.
C. If the pressure drops radically, the alignment pin in the lock will damages.
A. If you want to use the STE specification properly, a high professional standard is required.
B. A high level of professionalism requires the correct use of STE specifications.
C. In order to use the STE specifications appropriately, high professionalism is needed.