347. If your reader must know about a specific condition before the start of a procedure or work step, give this condition first

A. This Specification was issued by the General Aviation Manufacturers Association.

B. This Specification was revised by the General Aviation Manufacturers Association.

C. This Specification was compiled by the General Aviation Manufacturers Association.

A. Documents must be temporarily edible.

B. Documents must be readily revisable.

C. Documents must be permanently durable.

A. Only approved personnel must operate the brakes.

B. Only trained personnel must operate the brakes.

C. Only approved people must operate the brakes.

A. Proper warnings and cautions shall be provided stead of the text while notes may precede or follow suitable text up to the material to be highlighted. warning, cautions and notes shall not show procedural steps nor shall they be numbered.

B. Unlike warnings and cautions which must lines in the rear of text, notes may precede or follow porper text up to the material to be highlighted, warning, cautions and notes shall not provide procedural steps nor shall they be numbered.

C. Like warnings and cautions which must lines in the rear of text, notes may precede or follow porper text up to the material to be highlighted, warning, cautions and notes shall not provide procedural steps nor shall they be numbered.

A. Even though this specification is conformed to recognized industry practices, it is prepared in broad genuine terms and it is recognized that problems will occur which are not handled enough by the specification.

B. Although this specification coheres with recognized industry practices, it is written in vast general terms and it is asserted that problems will appear which are not treated sufficiently by the specification.

C. Though this specification complies with accepted industry practice, it is compiled in wide generic terms and it is recognized that problems which are not treated adequately by the specification will arise.

A. Consecutive alarms are most unusual caused by an intermittent short in the detector system wiring;

B. Intermittent alarms are most frequent caused by an consecutive short in the detector system wiring;

C. Intermittent alarms are most often caused by an occasional short in the detector system wiring;

A. 此外,所有手册的序言将醒目地显示以下声明:“这本手册包含FAR___部要求的维修信息”(根据需要插入23或25部)。

B. 此外,所有手册的附录上醒目地显示以下声明:“这本手册包含FAR___部要求的操作信息”(根据需要插入23或25部)。

C. 此外,所有手册的封面将在封面上醒目地显示以下声明:“这本手册包含FAR___部要求的维修信息” (根据需要插入23或25部)。

A. Set the air conditioning switch to the up position.

B. Place an air conditioning switch above the normal position.

C. Put one of the pack switches in the HIGH position

A. Make sure that the BLEED pushbutton switch is closed (the ON icon is off)

B. Make sure that the BLEED pushbutton switch is opened(the ON mark is off).

C. Make sure that the BLEED pushbutton switch is released (the ON legend is off).

A. Acceptable

B. Acceptance

C. Accept