A、 When the cumulative revised pages (including back-up pages) exceeds 60% of the total pages of the manual, a reissue should be prepared.
B、 If the updated pages, including back-up pages, were less than 60% of the total page of the manual, a new manual should be copied.
C、 Up to 60% of total pages (including back-up pages) were accumulated by mistake, the manual should be rewritten.
答案：A
A、 When the cumulative revised pages (including back-up pages) exceeds 60% of the total pages of the manual, a reissue should be prepared.
B、 If the updated pages, including back-up pages, were less than 60% of the total page of the manual, a new manual should be copied.
C、 Up to 60% of total pages (including back-up pages) were accumulated by mistake, the manual should be rewritten.
答案：A
A. 双面打印除线路图和折页外的所有页。
B. 双面打印除线路图外的所有折页。
C. 除了折叠的线路图外,双面打印所有页面。
A. The installation angle of the horizontal stabilizer can be adjusted.
B. Incidence of the horizontal stabilizer is variable.
C. You can adjust the incidence of the horizontal stabilizer.
A. OCCUR
B. FOUND
C. ARISE
A. Supply airspeed instructions and the operational significance of such instructions.
B. Provide airspeed limitations and the operational instruction of such limitations.
C. Provide airspeed limitations and the operational significance of such limitations.
A. Find out which door has a fault and is closed.
B. Make sure that which door has a failure.
C. Find out which door has not closed.
A. 在产品简洁性允许的情况下制造商还可以选择对相关系统进行分组。
B. 在产品简洁性允许的情况下制造商还可以选择同一组别的相关系统。
C. 在产品相似性允许的情况下制造商还可以选择对相关系统进行分组。
A. Discard the removed fasteners.
B. Throw away the removed components.
C. Leave out the removed gaskets.
A. CONTAINS
B. COVERS
C. COMPRISES
A. 拆卸密封胶和钝铁锹。
B. 用锋利的铲子去除密封胶。
C. 用钝刮刀刮掉密封胶。
A. Dry all metal parts that have different metal inserts or deep blind holes in an oven at 225 to 275℉ (107 to 135℃) for a minimum of one hour.
B. Put all different metal inserts or deep blind holes metal parts in an oven at 225 to 275℉ (107 to 135℃) for a maximum of one hour.
C. All metal parts that have different metal inserts or deep blind holes are dry in an oven of 225 to 275℉ (107 to 135℃) for a minimum of one hour.
