A、 The fairway and the runway centerline should align.
B、 The localizer course is aligned with the centerline of the runway.
C、 The localizer aligns with the center of the runway.
答案:B
A、 The fairway and the runway centerline should align.
B、 The localizer course is aligned with the centerline of the runway.
C、 The localizer aligns with the center of the runway.
答案:B
A. 系统中用来引导和分配空气的部分。包括设备架冷却系统和项目,如鼓风机、喷头、管道、进口、单向活门等,不包括增压和温度控制部分的活门。
B. 系统中用来通风和分配空气的部分。包括电子舱冷却系统和项目,如鼓风机、喷头、管道、进口、单向活门等,不包括增压和温度控制部分的活门。
C. 系统中用来引导和分配空气的部分。包括设备架冷却系统和项目,如排气扇、漏斗、管路、进气道、单向活门等,不包括空调和温度控制部分的活门。
A. Check whether the linkage moves slightly or not.
B. Examine the linkage for smooth movement.
C. Inspect the status of the linkage movement.
A. The difference between the two sizes must be 0.10mm or less.
B. The difference between the two dimensions must exceed 0.10mm.
C. The error between the two sizes must be less than 0.10mm.
A. Each manufacturer is expected to reasonably abide by the Specification content and arrangement.
B. Each manufacturer is expected to reasonably agree with the Specification content and arrangement.
C. Each manufacturer is expected to reasonably substitute the Specification content and arrangement.
A. 确保装置运转良好。
B. 确保装置满足要求。
C. 确保组件是令人满意的。
A. Boost pump is generally used in lubrication system.
B. Boost pump is usually driven by electrical power.
C. Boost pump is mounted on the engine’s accessory gearbox and driven by the gearbox.
A. This shows that a backup relay may be installed;
B. This indicates that an additional relay may be installed;
C. This shows that an ordinary relay may be installed;
A. 手册中的计量单位必须一致
B. 手册中的计量单位必须与实际的情况下保持一致
C. 手册中的计量单位可以实际可用
A. ADVISE
B. SUGGEST
C. RECOMMEND
A. Uncontrolled system or old equipment cause hydraulic fluid flow from hydraulic system A to B.
B. If you fail to operate the system control properly or the equipment is damaged, the hydraulic fluid will be transferred between hydraulic system A and B.
C. Flow of hydraulic fluid between hydraulic system A and B result in accidental operation of system controls or damaged equipment.