A、 数量
B、 数值
C、 读数
答案:B
A. Material supported by the manufacturer for microfilming, including removals, shall be given on one edge only in a form suitable for photographing.
B. The manufacturer for microfilming, including adjustments, shall be provided on one edge only in the format of suitable for photographing.
C. Material supplied by the manufacturer for microfilming, including revisions, shall be provided on one side only in a form suitable for photographing.
A. 内部逻辑可以根据温度的突然变化进行调整。
B. 温度的突然改变调整了外部逻辑。
C. 国际逻辑学内容是温度的突然变化。
A. 在接触到升降舵调整片后缘时,将指示器归零
B. 在指示器接触到升降舵调整片前缘时,将指示器归零
C. 当连接到升降舵调整片前缘时将,指示器一次性归零
A. REPAIR or MODIFICATION can be found directly below the inspection procedure part, extending from left to right edge, listing repair or modification instructions and may refer to standard repairs in other documents, or special repairs or alternations defined elsewhere (e.g., service notices, service packs, etc.)
B. REPAIR or MODIFICATION is located directly under the inspection procedure section, extending from left margin to right margin of the page. Repair or modification instructions are stated in it and it may refer to standard repairs in another document, or special repairs or modifications clarified elsewhere (e.g., service kit, service bulletin, etc.)
C. REPAIR or MODIFICATION is positioned directly under the inspection procedure section, extending from left to right edge, describing repair or modification instructions and may use normative repairs in other documents, or special repairs or alterations dedicated elsewhere (e.g., service kit, service bulletin, etc.)
A. Each Chapter or Section is to begin with a specific instruction of the system and its Operation and should be labeled Description and Operation"."
B. A general description of the system begins with each Chapter or Section and its operation and should be labeled Description and Operation"."
C. Each Chapter or Section is to start with a general description of the system and its operation and should be labeled Description and Operation"."
A. EAT
B. INGEST
C. SWALLOW
A. symbol
B. label
C. mark
A. The pack OFF light may go off as soon as the engine starts.
B. The pack should begin to operate two minutes after one engine starts.
C. The pack starts to operate as the engine starts, but the pack OFF light stays on until two minutes after the start.
A. GETS
B. SENSES
C. OBTAINS
A. 该部分系统用于控制空气中的水分,控制臭氧浓度,从经过调节的空气中过滤掉碎片,并在必要时用除臭剂,杀虫剂等处理空气,如适用。
B. 该部分系统用于控制空气中的浓度,控制臭氧水分,从经过调节的空气中过滤掉碎片,并在必要时用除臭剂,杀虫剂等处理空气,如适用。
C. 该部分系统用于控制空气中的水分,控制臭氧浓度,从经过调节的空气中过滤掉碎片,并在必要时用芳香剂,喷雾剂等处理空气,如适用。