1098. THE FLAG( ) INTO VIEW

A. The direction of fluid flowing through the axial turbine is almost perpendicular to the turbine shaft.

B. The direction of fluid flowing through the axial turbine is almost parallel to the turbine shaft.

C. The direction of fluid flowing through the axial turbine is almost parallel to the turbine wheel.

A. Check such system to determine the cause of interference.

B. Examine part of the system to find the cause of the interference.

C. Examine all of the system to find the cause of the interference.

A. The removal step in the replacement of hydraulic reservoir might break down into such following key items.

B. The installation step in the replacement of pneumatic reservoir might be split up into such key items that follow.

C. The removal step in the replacement of hydraulic pump might be divided into the above-mentioned key items.

A. The water quantity transmitter is easily damaged;

B. The water quantity transmitter is expensive;

C. The water quantity transmitter is unstable;

A. REPAIR or MODIFICATION can be found directly below the inspection procedure part, extending from left to right edge, listing repair or modification instructions and may refer to standard repairs in other documents, or special repairs or alternations defined elsewhere (e.g., service notices, service packs, etc.)

B. REPAIR or MODIFICATION is located directly under the inspection procedure section, extending from left margin to right margin of the page. Repair or modification instructions are stated in it and it may refer to standard repairs in another document, or special repairs or modifications clarified elsewhere (e.g., service kit, service bulletin, etc.)

C. REPAIR or MODIFICATION is positioned directly under the inspection procedure section, extending from left to right edge, describing repair or modification instructions and may use normative repairs in other documents, or special repairs or alterations dedicated elsewhere (e.g., service kit, service bulletin, etc.)

A. 人工超控起动顺序。

B. 按手册重写起动顺序。

C. 手动覆盖起动序列。

A. 三台计算机收集数据,与系统参数起放在连接到显示器组件的数据链路上

B. 三台计算机从系统中更正数据和参数,将它们放在连接到显示器组件的数据链路上

C. 三台计算机收集系统数据和参数,并通过数据链接将它们一起传送给显示组件

A. Each surge tank has a vent scoop and pressure relief valve on its access door.

B. The vent scoop and pressure relief valve each has an access door in the surge tank.

C. The surge tank has a vent scoop and pressure relief valve on each access door.

A. Compare the width on the flange between points A and B.

B. Measure the distance on the flange at points A and B.

C. Test the length of points A and B on the flange.

A. All of operations, there are key items that are important to the job.

B. In very few operations there are key items that are significant to the job.

C. In most operations there are key items that are significant to the job.