A、 Movement of the center of gravity is not depending on the loads on the wings.
B、 Movement of the center of gravity is relative with the loads on the wings.
C、 Movement of the center of gravity is regardless to the loads on the wings.
答案：B
A、 Movement of the center of gravity is not depending on the loads on the wings.
B、 Movement of the center of gravity is relative with the loads on the wings.
C、 Movement of the center of gravity is regardless to the loads on the wings.
答案：B
A. A separate document should be prepared for FAA approved airworthiness limitations which are excluded in the primary maintenance manual.
B. FAA approved airworthiness limitations shall be prepared as a separate document for inclusion in the principal maintenance manual.
C. FAA approved airworthiness limitations must be contained as an integrated documentation for inclusion in the main maintenance manual.
A. 在起飞和飞行期间,在发动机故障的情况下应对飞机采取相应措施。
B. 对于所有飞机在起飞和飞行过程中发生的所有发动机故障,应提供相应的程序。
C. 在起飞和飞行期间,对于飞机的各种发动机故障,应执行相应程序。
A. This section includes all the fuel consumption information for the pilot to use during the flight and landing.
B. In this section, the pilot can find the recommending fuel saving information to use during takeoff and flight.
C. The recommended fuel conservation information shall be integrated into this section to show the pilot how to minimize the fuel usage during the operation of the airplane.
A. 联邦航空管理局意识到,遵守本规范将导致内容的高度标准化和所有飞机类型的格式,这将导致安全水平等于或高于FAR23下面所要求的水平。
B. 联邦航空管理局意识到,和本规范一起遵守使内容和格式高度标准化,对于所有类型飞机这将导致相当于或高于FAR23所要求的安全水平。
C. 联邦航空管理局认为,完成对本规范的符合性对照会使所有机型的内容和格式高度标准化。这将达到或高于FAR23所要求的安全水平。
A. 电瓶为紧急出口的照明电路供电
B. 闭合电瓶电路给应急出口灯供电
C. 应急出口灯由电瓶电路控制
A. The pneumatic system gets compressed air from the pneumatic air sources and supplies the compressed air through ducts to the user systems.
B. The pneumatic system gets compressed air from the pneumatic air sources and supplies the compressed air through manifold to the user systems.
C. The pneumatic system gets comprised air from the pneumatic air sources and supplies comprised the air through ducts to the user systems.
A. If the engine appears to be heating, turn it off.
B. If the engine appears to be overheating, turn it off.
C. If you think the engine is too hot, turn the switch to off"＇"
A. Clean the surface to make sure that the sealing is satisfactory.
B. Clean surfaces to ensure the bonding as required.
C. Clean the surface to make sure that the bond is satisfactory.
A. 本制度不会取代CAP中未包括事项的常规沟通渠道。
B. 本系统无法超越CAP涵盖的常规沟通渠道
C. 未包括在CAP中的常规沟通渠道不能代替本制度。
A. 人工超控起动顺序。
B. 按手册重写起动顺序。
C. 手动覆盖起动序列。
