1330. Make sure that the doors are closed during the pressurization test

A. Make sure that drag struts do not obstruct landing gear.

B. Make sure that studdle do not obstruct landing gear.

C. Make sure that the drag struts do not catch on the landing gear.

A. Set the suitable L PACK switch or the R PACK switch to the AUTO position. L PACK switch and the R PACK switch are on the p5-10 air conditioning panel.

B. Set L PACK Switch or R PACK Switch on Suitable p5-10 air conditioner panel to AUTO position.

C. Set the applicable L PACK switch or the R PACK switch to the AUTO position. The R PACK switch is on the p5-10 air conditioning panel.

A. Because of the speed of the AC, the magnetic fields and electric fields created around the emission do not have time to completely collapse as the AC cycles;

B. Because of the speed of the AC, the electromagnetic fields and electric fields created around the antenna do not have time to completely collapse as the AC cycles;

C. Because of the speed of the DC, the electromagnetic fields and electric fields created around the antenna do not have time to completely collapse as the DC cycles;

A. 将旋转开关设置为输入

B. 将旋转开关设置为输出

C. 将活动开关设置为输入

A. 将大量压缩空气从气源输送到其他系统,如环境控制、除冰等连接点的组件和部件(管道和活门)。

B. 将高压空气从气源输送到其他系统,如环境控制、除冰等连接点的组件和部件(管道和活门)。

C. 将大量压缩空气从引气管路输送到其他系统,如环境控制、除冰等连接点的组件和部件(管道和活门)。

A. When you push the FAULT/INOP test switch, faults are emulated to do a check of the circuit to see if it has ability to detect a fault.

B. Faults are similar when doing a check of the circuit ability to correct a fault When you push the FAULT/INOP test switch.

C. When pushing the FAULT/INOP test switch, faults are shown so that we can check the circuit ability to eliminate a fault.

A. 垂尾顶部安装有垂直安定面。

B. 机身后段顶部安装有垂尾。

C. 垂直安定面安装在机身尾段顶部。

A. The airflow then goes along the above and bottom surfaces of the aileron.

B. The air value then goes through the cover and bottom surfaces of the flank.

C. The airflow then goes along the top and bottom surfaces of the slats.

A. The main gear leg could be held by the side stay.

B. The main gear leg could be hampered by the side stay.

C. The main gear leg could be contained by the side stay.

A. The distance between the edge of the panels and the partition must be less than 0.05 mm.

B. The distance between the edge of the panel and the partition must be equal to 0.05mm

C. The distance between the edge of the panel and the partition must be 0.05 mm or less.