A、 Copy that,the plane press
B、 Roger that,the plane dispatch
C、 Roger that,the plane leave
答案：B
A、 Copy that,the plane press
B、 Roger that,the plane dispatch
C、 Roger that,the plane leave
答案：B
A. 这并不是所有可能的技术名称的完整列表。
B. 这不是所有可能的技术名称的完成列表。
C. 这不是所有可能的技术员名称的完整列表。
A. 飞行表面包括襟翼、副翼、扰流板、调整片、阻力和平衡装置等;
B. 飞行表面包括副翼、襟翼、扰流板、调整片、阻力和平衡装置等;
C. 飞行表面包括副翼、襟翼、扰流板、调整片、拉力和平衡装置等;
A. Install packing and support rings on bearing. Glide bearing into cylinder until it is bottomed.
B. Install packing and backward rings on bearing. Slash bearing into cylinder until the bottom is visible.
C. Install packing and alternative rings on bearing. Skid bearing into cylinder until you see the bottom.
A. It is stated int the document that you should inform the FAA about the alterations you＇ll perform on the airplane to insure the airworthiness of the airplane.
B. The document says that the FAA should be involved in any alterations on airplane so to insure that the airplane will not violate any airworthiness.
C. The document sets forth that you should contact the FAA before any alterations on airplane to make sure that the airplane is airworthy continuously.
A. REPAIR or MODIFICATION can be found directly below the inspection procedure part, extending from left to right edge, listing repair or modification instructions and may refer to standard repairs in other documents, or special repairs or alternations defined elsewhere (e.g., service notices, service packs, etc.)
B. REPAIR or MODIFICATION is located directly under the inspection procedure section, extending from left margin to right margin of the page. Repair or modification instructions are stated in it and it may refer to standard repairs in another document, or special repairs or modifications clarified elsewhere (e.g., service kit, service bulletin, etc.)
C. REPAIR or MODIFICATION is positioned directly under the inspection procedure section, extending from left to right edge, describing repair or modification instructions and may use normative repairs in other documents, or special repairs or alterations dedicated elsewhere (e.g., service kit, service bulletin, etc.)
A. The Introduction Section of the Maintenance Manual should contain either a list of vendor publications or refer to the location of such lists whether they are included in component descriptions or provided in separate documents.
B. The Introduction Section of the Maintenance Manual should contain either a list of vendor publications or refer to the sequence of such lists whether they are included in system descriptions or provided in separate documents.
C. The Introduction Section of the Maintenance Manual should contain either a list of vendor publications or refer to the location of such lists whether they are included in system descriptions or provided in separate documents.
A. 获取桶燃油,并做一项含水量测试
B. 取份燃油样品,并进行一项水污染测试
C. 获取一份燃油资料,并分析含水量
A. 图表显示了起落架、控制面板、插塞和口盖系留点等的位置;
B. 表格显示了起落架、控制锁、插塞和口盖、系留点等的位置;
C. 图表显示了起落架、控制面锁、插塞和口盖、系留点等的位置;
A. Some chemicals can not be used if they are well kept.
B. Some chemicals must be well kept as long as they can ben used.
C. Some chemicals can be used only if they are well kept.
A. Operate the actuator through three cycles.
B. Do the/actuator through three times.
C. Cycle actuator three times.
