A、 Troubleshooting: messages explaining possible failures and corrective measures must be covered in this handbook.
B、 You may find the troubleshooting information about the malfunctions and the related measures for them in this manual.
C、 Troubleshooting information describing probable malfunctions and the remedial actions of those malfunctions shell be provided in this manual.
答案：C
A、 Troubleshooting: messages explaining possible failures and corrective measures must be covered in this handbook.
B、 You may find the troubleshooting information about the malfunctions and the related measures for them in this manual.
C、 Troubleshooting information describing probable malfunctions and the remedial actions of those malfunctions shell be provided in this manual.
答案：C
A. This Section of the Pilot＇s Operating Handbook including only those limitations required by regulation or necessary for safe operation of the airplane is approved by the regulatory authority.
B. This Section of the Pilots Operating Handbook shall include only two kinds of limitations. One is the limitations required by regulation The other is the limitations necessary for safe operation of the airplane and approved by the regulatory authority.
C. Those limitations required by regulation contained in this Section of the Pilot＇s Operating Handbook are approved by the regulatory authority, it＇s necessary for safe operation of the airplane.
A. 松开卡箍,将螺钉固定到支架上
B. 松开螺钉,将卡箍固定到支架上。
C. 松开将卡箍固定到支架上的螺钉。
A. For normal operations, make sure the pressure relief valve is closed. An open pressure relief valve is a symptom of a problem in the fuel vent system.
B. For normal operations, make sure the shut off relief valve works; If you open pressure relief valve, that indicates a problem in the fuel vent system.
C. For normal operations, make sure you close the pressure relief valve. If you leave it open a problem will be shown in the fuel vent system.
A. 如果燃油过滤器内有金属颗粒,检查过滤器滤是否磨损
B. 如果滑油过滤器内有金属颗粒,检查过滤器滤是否磨损
C. 如果液压油过滤器内有金属颗粒,检查过滤器滤是否磨损
A. The specification gives the symbols for relays, diodes, and other parts of the system.
B. The specification gives the requirement for markings on relay, triode and other parts of the system.
C. The specification excludes symbols for relays, diodes, and other system parts.
A. 用张力计测量钢索的张力到正确的值
B. 用张力计把钢索的张力校准到正确的值
C. 用张力计将电缆的张力校准到正确的值。
A. It is possible to use the same page to include the examples, associated conditions and technique. Should there be no necessary information included, refer to the page facing the chart.
B. If the same page contains examples, associated conditions and techniques, you need to include all the necessary information, it is forbidden to use the page that the figure faces.
C. Where possible, examples, associated conditions and technique should be presented on the same page as the chart. If space is not enough to include the necessary information, then the page facing the chart should be used.
A. The safety procedures are provided by the operators.
B. The safety procedures are provided to the manufacturers.
C. The safety procedures are provided by the manufacturers.
A. The right fan provides more air, so it can not be replaced with the left one.
B. The left fan provides more air, so it can not be replaced with the right one.
C. The two fans can be changed each other.
A. ASD感谢所有对本规范做出整理的组织、公司和个人。
B. ASD向所有对本规范做出贡献的组织、公司和个人表示感谢。
C. ASD感谢所有对本特例做出解释的组织、公司和个人。
