A、 To found the basis for those items, the following conceptions have been made.
B、 In order to set up the basis for those items to be included, make the following assumptions.
C、 Do the following assumptions to build up the basis for those items to be excluded
答案:B
A、 To found the basis for those items, the following conceptions have been made.
B、 In order to set up the basis for those items to be included, make the following assumptions.
C、 Do the following assumptions to build up the basis for those items to be excluded
答案:B
A. “通用规范”部分包含适用于编制所有维护标准的技术出版物要求。
B. “通用规范”部分包含适用于编制所有操作手册的技术出版物指南。
C. “通用规范”部分包含适用于编制所有维护手册的技术出版物指南。
A. Replace components that worn more than the maximum limits.
B. Replace components that worn more than the less than limits.
C. Replace components that worn more than the minimum limits.
A. Do not enter the engine test area without approval.
B. Do not make entrance to the engine test area without approval.
C. Do not go into the engine test area without approval.
A. arms
B. activates
C. releases
A. If you do not safety the door, strong winds must cause damage to the structure.
B. If you do not safety the door, damage to the structure due to strong winds is acceptable.
C. If you do not safety the door, damage to the structure due to strong winds is probable.
A. For the thermocouple leads are designed to provide a specific amount of resistance in the thermocouple circuit (usually very little). The amount of voltage produced by the identical metals when heated is measured in millivolts;
B. The amount of voltage produced by the approximate metals when heated is measured in millivolts. Therefore, thermocouple leads are designed to provide a specific amount of resistance in the thermocouple circuit (usually very little);
C. Because of thermocouple leads are designed to provide a specific amount of resistance in the thermocouple circuit (usually very little).The amount of voltage produced by the different metals when heated is measured in millivolts;
A. The valves are double flap spring-loaded valves mounted on the wheel well side of the front bulkhead of the wheel well, with 9-inch (228 mm) pipes from the assembly into the space above the wing.
B. The valves which are attached to the wheel well side of the wheel well forward bulkhead, where the 9-inch (228 mm) ducts from the packs get into the space above the wings,are of dual flapper spring-loaded type.
C. The valves which are fixed to the wheel well side of the wheel well forward bulkhead are dual flapper spring-loaded type valves where the 9-inches (228 mm) tubes from the units enter into the space above the wings.
A. 交流电源系统设计避免同一个电源同时给两个负载供电。
B. 交流电源系统设计防止两个电源同时向同一负载供电。
C. 备用电源系统被设计成避免两个电源同时向同一用户供电。
A. This document provides optional information to the befitting airplane maintenance manual(s).
B. This document provides supplemental information to the applicable airplane maintenance manual(s).
C. This document provides extra information to the accessible airplane maintenance manual(s).
A. Install caps on the plug to make sure that unwanted material does not go into the receptacles.
B. Install caps on the receptacles to make sure that unwanted material does not go into the receptacles.
C. Install caps on the pin to make sure that unwanted material does not go into the receptacles・