A、 The computer gets this data from five sensors.
B、 The computer gets this date from five sheets.
C、 The computer gets this data from five source.
答案:A
A、 The computer gets this data from five sensors.
B、 The computer gets this date from five sheets.
C、 The computer gets this data from five source.
答案:A
A. After three full cycles, extend and retract the actuator.
B. You should extend and retract the actuator through three complete cycles.
C. Do nothing to the actuator after three complete cycles.
A. Fill the outer tank before you fill the inner tank.
B. Fill the inner tank before you fill the outer tank.
C. Fill the inboard tank before you drain the overboard tank.
A. Pressurize the Pneumatic System.
B. Depressurize the hydraulic System.
C. Depressurize the Pneumatic System.
A. When you need to understand a schematic diagram, use arrows to indicate flow orienting.
B. Arrows shall be used to indicate flow ends when needed to understand the schematic diagram.
C. When need to comprehend the chart, you should use arrows point to the direction.
A. However, manufacturers are following the same fundamental systems and sequence of subject arrangements even if some systems, which are not available, may be bypassed.
B. Nevertheless, each manufacturer is expected to follow the same sequence of basic system and subject arrangements even though some systems may be omitted when not applicable.
C. Even so, all manufacturers are expected to submit to the same arrangements of main systems and subject sequences even though certain systems would be ignored when not applicable.
A. 制动系统用于降低滑行速度以及发动机停车状态下的停止螺旋桨旋转
B. 制动系统是用来减少停车时间或在发动机关车的情况下使螺旋桨停止转动
C. 在发动机低速运转或螺旋桨低速旋转时,制动系统能快速刹住
A. If there is no respond from the tower, select a different frequency and contact again.
B. If there is not any answer from the tower, use a different tunnel.
C. If the tower does not respond, use a different radio device.
A. 如果剪切销断裂,检查拖把。
B. 如果销钉断裂,检查拖把。
C. 如果剪切销断裂,给拖把做测试。
A. 松开断路测试开关
B. 按压短路测试开关
C. 松开短路测试开关
A. Landing gear position will not effect its speed;
B. The stall speed will be effected by landing gear position;
C. The stall speed is not effected by landing gear position;