A、 对加载条件和安全裕度共同产生的结果进行了评价
B、 对加载条件和安全裕度产生的结果进行了评价
C、 对加载条件和由此产生的安全裕度进行了评价
答案：C
A、 对加载条件和安全裕度共同产生的结果进行了评价
B、 对加载条件和安全裕度产生的结果进行了评价
C、 对加载条件和由此产生的安全裕度进行了评价
答案：C
A. Even though this specification is conformed to recognized industry practices, it is prepared in broad genuine terms and it is recognized that problems will occur which are not handled enough by the specification.
B. Although this specification coheres with recognized industry practices, it is written in vast general terms and it is asserted that problems will appear which are not treated sufficiently by the specification.
C. Though this specification complies with accepted industry practice, it is compiled in wide generic terms and it is recognized that problems which are not treated adequately by the specification will arise.
A. Troubleshoot the VHF Communication system per FIM
B. Do the troubleshooting procedure on the VHF navigation system.
C. Do the fault isolation procedure for the ADIRU system.
A. 检查开口是否有从边角开始的裂纹。
B. 检查转角处的裂纹是否从这里开始。
C. 检查裂纹的开口是否有从边角开始的。
A. 执行绕机检查,清除静压孔的损坏和堵塞,检查整流罩锁和迎角传感器没有损坏。
B. 执行绕机检查,确保静压孔没有损坏和堵塞,检查雷达罩锁和迎角传感器没有损坏。
C. 执行目视检查,确保静压孔没有损坏和堵塞,检查雷达罩锁和迎角传感器没有损坏。
A. Test the actuator to check its operation.
B. Operate and test the actuator.
C. The actuator need operation as a test.
A. A brush is cleaned by the filter element.
B. The filter element and a brush are clean.
C. Use a brush to clean the filter element.
A. If the temperature values are under the eligible limits, decrease the power.
B. Decrease the power as long as the temperature values are less than the certified limits.
C. If the temperature values are likely to be more than the allowed limits, decrease the power.
A. 如果获得一个以上的类别认证,则每一类别的重量均应给予限制。
B. 如果获得的认证多于一个类别,则每一类别的重量均须加以限制。
C. 如果在一个以上的类别中获得认证则各类别重量,连同任何相关限制,都应针对各类别给出。
A. station shows the height along the fuselage between the reference datum and the position
B. station is the distance of a Point of fuselage to the location of reference datum along the
C. station means a position along the fuselage measured in inches from the reference datum
A. Ensure the brown VALVE CLOSED light below each switch comes on.
B. Make sure the amber VALVE CLOSED light below each switch goes off.
C. The green VALVE CLOSED light is off.
