2254. Use 14-point uppercase bold for the word WARNING and 10-point uppercase bold for the WARNING TEXT

A. Replace the PTU check valve

B. Interchange the PTU one way valve.

C. Change the PTU return valve

A. Continuing Airworthiness Programs may be prepared according to the related Federal Aviation Regulations for all types of general aviation airplanes and components.

B. All types of general aviation airplanes and components are certified by the applicable Federal Aviation Regulations which require the preparation of Continuing Airworthiness Programs.

C. Continuing Airworthiness Programs may be prepared for all types of general aviation airplanes and components certificated under the applicable Federal Aviation Regulations.

A. Nornencluture shall be similar throughout all technical data obtained by the Customer.

B. Nornencluture shall be consistent throughout alI technical data given to the Customer.

C. Nornencluture must be similar throughout all technical data provided to the Customer.

A. 在可行的情况下,语言和书写风格要遵守相应的规则和STE字典

B. 在可能和实际的情况下,语言和写作风格要遵守STE的规则和字典。

C. 在切实可行的情况下,STE字典和规则要遵守其语言及书写风格。

A. In order to do the engine bleed system leak check use APU to pressurize the system and check if there are leaks in the sensing tube and these system components.

B. The leak inspection of the engine bleed air system describes how to use APU to pressurize the system to inspect whether the sense lines and the system parts leak or not.

C. The way to check the leakage of the senses pipes and the system components by compressing system using APU is described.

A. Do not exceed the speed limit while extending or retracting the Landing gears;

B. Do not extend or retract landing gear too fast;

C. Do not extend or retract landing gear above this speed;

A. 只有当EEC有电时,EGT才显示。

B. 当EEC有电时,只有EGT显示。

C. 只要EEC有电,EGT就显示。

A. 旋转控制开关到完全关闭位置。

B. 旋转控制开关到完全接近位置。

C. 按压控制开关到完全关闭位置。

A. In this configuration, we required a same test procedure.

B. This configuration demands a different test procedure.

C. In this configuration, a different test procedure is required or not.

A. Both 28v dc and 115v are supplied to the ignition system.

B. Either 28v dc or 115v is supplied to the ignition system.

C. Only 28V dc power is supplied to the ignition system.