A、 Hydraulic fluid has no effect on painted surfaces.
B、 Hydraulic fluid has positive influence on painted surfaces.
C、 Hydraulic fluid has passive influence on painted surfaces.
答案:C
A、 Hydraulic fluid has no effect on painted surfaces.
B、 Hydraulic fluid has positive influence on painted surfaces.
C、 Hydraulic fluid has passive influence on painted surfaces.
答案:C
A. Pull out the circuit breaker.
B. Push in the circuit breaker.
C. Remove the circuit breaker.
A. 确保表显数值与油箱加油量一致。
B. 确保设备测量值与燃油箱的实际油量一致。
C. 确保仪表上的指示与油箱内的油量一致。
A. The construction of the inlet is connected with the size of the connector shell.
B. The configuration of the inlet is related to the dimension of the connector shell.
C. The conduction of the intake is related to the dimension of the connector shell.
A. The Handbook producer should average the material within paragraphs in a way he considers to be most informative to the kind of pilot experienced to use the Handbook.
B. The Handbook manufacturer should arrange the material within paragraphs in a sense he considers to be most useful to the kind of pilot anticipated to use the Handbook.
C. The Handbook operator should arrange the document within paragraphs in a manner he considers to be most incentive to the kind of pilot expected to use the Handbook.
A. 确保正确安装轴承
B. 确保正确安装机轮
C. 正确的安装轴承
A. CAP检查列出制造商建议的零件或组件的报废时间(使用小时数、循环或其他适当的决定因素)和FAA要求的关于时寿零件或组件的报废(维护拆换)时间。
B. CAP检查设定四家推荐的制造商的零件或组件退役时问(使用时间周期或其他适当的计算方法)和FAA要求的时间限制零组件的退役(维护拆换)时间。
C. CAP检查包在建议的厂家零部件退役时间(使用时间周期或其他合适的计量因子)和FAA要求的零部件退役(不服役)时间后进行。
A. Do this procedure again.
B. Repeat this procedure.
C. Do this procedure two times.
A. The direction of tail wind is the same as that of the aircraft is moving.
B. The direction of tail wind is opposite to that of the aircraft is moving.
C. When the aircraft is flying with a tail wind, its speed over the ground is equal to its speed through the air, minus the speed the air is moving over the ground.
A. Make sure that the doors are closed throughout the pressurization test.
B. Make sure that the doors are closed within the pressurization test.
C. Make sure that the doors are closed as if the pressureization test is being done.
A. 最后的分类,可以识别系统或子系统中的各个单元。
B. 允许识别系统或子系统中独立单元的最终划分。
C. 最后的分类,可以鉴别整体单元中的系统或子系统。