A、 旋转控制开关到完全关闭位置。
B、 旋转控制开关到完全接近位置。
C、 按压控制开关到完全关闭位置。
答案：A
A、 旋转控制开关到完全关闭位置。
B、 旋转控制开关到完全接近位置。
C、 按压控制开关到完全关闭位置。
答案：A
A. Transport the part to the overhaul shop.
B. Transport the part to the maintenance shop.
C. Remove the part to the overhaul shop.
A. If you must add pages after the ahead printing, then the page should have the number of the preceding page and an alphabetic suffix.
B. In the event a page must be added pursuant to the original printing, the page shall carry the number of the preceding page with a letter suffix added.
C. If you must add pages after the individual printing, then the page should contain the serial number of the preceding page,and add a suffix letters.
A. It is standard to do the procedure in this service bulletin.
B. It is necessary to do the procedure in this service bulletin.
C. It is mandatory to do the procedure in this service bulletin.
A. Before you refuel the aircraft, a small quantity of oil comes out of the vent line.
B. When you refuel the aircraft, a small quantity of fuel comes out of the vent line.
C. After you refuel the aircraft, a small quantity of fuel comes out of the vent line.
A. The information is applicable to the entire system.
B. The message is apply to the section system.
C. This information is apply to the whole system.
A. If you do not safety the door, strong winds must cause damage to the structure.
B. If you do not safety the door, damage to the structure due to strong winds is acceptable.
C. If you do not safety the door, damage to the structure due to strong winds is probable.
A. 如果制造商选择提供全面的检查信息以补充基本的飞机维修手册,则本规范是持续适航程序检查文件的示例并建立了标准。
B. 如果制造商选择提供全部的检查信息以配合基本的飞机维修手册,则本规范是持续适航程序检查文件”的模板并建立了标准。
C. 如果制造商选择提供全面的检查信息以补充基本的飞机维修手册,则本手册是持续适航程序检查文件的示例并建立了标准。
A. For “emergency”， the related failure should be responded immediately， for example， the total engine failure， fire or smoke sudden cabin pressure lost.
B. An “Emergency” almost including a serious failure that requires later response， such as a total engines failure， flame out or smoke or rapid cabin pressurization.
C. For “emergency”， the related failure should be treated immediately， for example， the total engine is not malfunctioning， fire or smoke sudden cabin pressure lost.
A. 检查部件的接合处及邻近区域。
B. 检查部件的表面以及相关区域。
C. 检查部件的内部以及相邻区域。
A. Adjust the clearance dimension between the extend proximity sensor[1A] and the target[1C] until the clearance dimension is out of range. Some of the ducts in the air distribution system are wrapped with compound material.
B. Adjust the clearance dimension between the extend proximity sensor[1A] and the target[1C] in case of the clearance dimension is out of tolerance. Some of the ducts in the air distribution system are wrapped with non-conductive material.
C. If the clearance dimension is not accurate,adjust the clearance dimension between the extend proximity sensor[1A] and the target[1C]. Some of the ducts in the air distribution system are wrapped with insulation material.
