2657. Manually override the start sequence

A. The fuselage is a semi-monocoque structure

B. The fuselage is a demi-plate.

C. The airframe is of half-shell structure.

A. The flight crew can get visual and aural indication about a fire in any of these fire alarm systems.

B. The fire alarms provide indications about afire in any of these systems to the flight crew in visual and aural ways.

C. Visual and aural indications are the fire alarms that the flight crew will get from any of these systems.

A. The gate is mainly used for passengers and crew entering and out of the aircraft.

B. There are doors for passengers and crew to get in and out of the aircraft.

C. The doors used for entrance and exit of the passengers and crew to and from the aircraft.

A. 用一块干净的布压在表面上

B. 用一块干净的布擦拭表面

C. 用一块干净的布修复表面

A. 不正确调整升降舵脚蹬上的止动螺栓可能导致损坏。

B. 不正确调整方向舵踏板的止动螺栓可能导致损坏。

C. 不正确调整方向舵脚蹬上的止动螺栓可能导致损伤。

A. This work is applicable to horizontal installations.

B. This work is applicable to direction installations.

C. This work is applicable to vertical installations.

A. For right-hand page, the page number at the lower right corner;

B. Date of issue or revision in the upper left corner;

C. When revised, each page shall bear the date of the revision at the lower right corner;

A. 力了给支持性软件产品的组织、公司和个人提供担保或认可,ASD、简化技术英语维护集团(STEMG)以及与STE生产相关的任何组织或公司将会提供培训或生产支持。

B. ASD、简化技术英语维护集团(STEMG)以及与STE生产相关的任何组织或公司均无意或暗示对提供培训或生产支持性软件产品的组织、公司和个人提供任何担保或认可。

C. 简化技术英语维护集团(STEMG)与生产相关的任何组织或公司均无意或暗示对提供培训或生产支持性软件产品的组织、公司和个人提供任何担保或认可,ASD除外

A. 量规的精度必须符合适用的质量标准。

B. 选择量规必须参照已有的质量标准。

C. 采购护目镜必须满足相应的质量标准。

A. REPAIR or MODIFICATION can be found directly below the inspection procedure part, extending from left to right edge, listing repair or modification instructions and may refer to standard repairs in other documents, or special repairs or alternations defined elsewhere (e.g., service notices, service packs, etc.)

B. REPAIR or MODIFICATION is located directly under the inspection procedure section, extending from left margin to right margin of the page. Repair or modification instructions are stated in it and it may refer to standard repairs in another document, or special repairs or modifications clarified elsewhere (e.g., service kit, service bulletin, etc.)

C. REPAIR or MODIFICATION is positioned directly under the inspection procedure section, extending from left to right edge, describing repair or modification instructions and may use normative repairs in other documents, or special repairs or alterations dedicated elsewhere (e.g., service kit, service bulletin, etc.)