A、 If the air intake flap is serviceable, lock the air inlet valve in the fully open position.
B、 If the air intake flap is not serviceable, do the deactivation procedure of the air inlet valve.
C、 If the air intake flap is not serviceable, disconnect the air inlet valve.
答案:B
A、 If the air intake flap is serviceable, lock the air inlet valve in the fully open position.
B、 If the air intake flap is not serviceable, do the deactivation procedure of the air inlet valve.
C、 If the air intake flap is not serviceable, disconnect the air inlet valve.
答案:B
A. 连接可以连接的导线
B. 把断开的导线重新断开
C. 连接断开的导线
A. roger that, we can release.
B. roger that, we can dispatch.
C. Roger, we can push back.
A. Each electrical system is identified by a code.
B. Each code of electrical system id identified.
C. Each system is identified by an electrical code.
A. During an in-flight start, the EEC selects either ignition exciter to get power.
B. If the engine need to start in flight, the EEC will selects both ignition exciters to get power.
C. During an in-flight start, one ignition exciter is active and the other one standby.
A. Verb phrase
B. verb sentence
C. Verb paragraph
A. 逆时针转动调节器五圈
B. 逆时针转动调节器5个咔嚓
C. 逆时针转动调节器五个单位
A. The smoke sensor in each detector monitors when the smoke density is above a previous limit. If the density keeps higher than the limit for about eight seconds, the sensor set the detector to the alarm condition.
B. The smoke sensor in each detector monitors for smoke density above a preset limit. If the density stays above the limit for appropriately eight seconds, the sensor sets the detector to the alarm condition.
C. The smoke transducer monitors for smoke density above a presumed limit of each detector. If the density remains over the limit about eight seconds, the transducer turn the detector to the alarm condition.
A. Increase the pressure until the flow starts again.
B. Add the pressure until the flow starts again.
C. Increase the pressure until the stream starts again.
A. 把上凸轮放到与拆下时所做标记一致的位置。
B. 上部卡箱安装的位置应该与拆卸标记保持一致。
C. 经同意后,对应拆卸时所作的标记将上部曲柄安装在位。
A. 校准空速指示的是飞机速度,修正了位置和仪表误差;
B. 校准空速是指修正了位置和仪表误差后飞机的指示速度;
C. 校准空速是指飞机的指示速度,及被改过的位置和仪表误差;