2104. Check that valve spindle does not bind or jam
A. 检查阀杆是否连接或卡紧
B. 检查阀芯是否堵塞或卡住
C. 检查阀轴是否卡滞或卡阻
https://www.shititong.cn/cha-kan/shiti/0009ffb1-44ba-e30e-c0b8-ef8d402da900.html
点击查看答案
153. If you push the LSK that is adjacent to EXIT, then the BITE will take you out of BITE test and put the airplane back to its usual condition
A. After pressing the LSK next to EXIT the BITE will take you out of BITE test and the airplane win return to its normal condition
B. The BITE will continue the BITE test and the airplane will go back to its usual condition when you push the LSK next to EXIT
C. The BITE will proceed the BITE teste and the airplane will go back to, its normal configuration after releasing the LSK that is adjacent to EXIT
https://www.shititong.cn/cha-kan/shiti/0009ffa1-9bf5-1342-c0b8-ef8d402da900.html
点击查看答案
1793. When a fire starts, the temperature increases and causes the detector to operate
A. 当火警启动时,温度增加并引起灭火器工作
B. 当火焰开如时,温度增加并造成触发器工作
C. 当起火时,温度升高并使探测器工作
https://www.shititong.cn/cha-kan/shiti/0009ffad-f67f-58ae-c0b8-ef8d402da900.html
点击查看答案
1739. Connect the disconnected wires
A. 连接可以连接的导线
B. 把断开的导线重新断开
C. 连接断开的导线
https://www.shititong.cn/cha-kan/shiti/0009ffad-f67e-aa4a-c0b8-ef8d402da900.html
点击查看答案
430. 在测试过程中,确保滑油液面在观察窗中可见
A. The oil level on the sight gauge must be visible during the test;
B. The oil quantity on the sight gauge must be visible during the test;
C. The oil level on the sight indicator must be visible during the test;
https://www.shititong.cn/cha-kan/shiti/0009ffa1-9bf8-b019-c0b8-ef8d402da900.html
点击查看答案
3158. Use a solution of soap and water to check that there are no air leaks at the pressurization tube connections between the air pressure filter assembly near the pneumatic crossover manifold duct in the left/right bays and the air charging valve manifold assembly in the right main landing gear wheel well
A. 使用肥皂和水溶液检查左/右舱气动交叉歧管导管附近的空气压力过滤器组件和右主起落架轮舱充气阀总管组件之间的增压管接头处没有漏气。
B. 使用肥皂和水的解决方案检查左/右舱气动交叉歧管导管附近的空气压力过滤器组件和右主起落架轮舱充气阀歧管组件之间的减压管接头处没有漏气。
C. 使用肥皂和水的解决方案检查左/右舱气动交换歧管导管附近的空气压力过滤器组件和右主起落架轮舱充气阀软管组件之间的增压管接头处没有释压。
https://www.shititong.cn/cha-kan/shiti/0009ffba-8e35-d4b7-c0b8-ef8d402da900.html
点击查看答案
2983. The autothrust system is on but not in operation
A. The autothrust system is not powered and cannot operate.
B. The autothrust system is shut off so it is not in operation.
C. The autothrust system is powered but not running.
https://www.shititong.cn/cha-kan/shiti/0009ffb5-69d4-c9bf-c0b8-ef8d402da900.html
点击查看答案
1707. Do not loosen the nut to align it
A. 不要拧紧螺母去压紧它
B. 不要旋转螺母去校准它
C. 不要拧松螺母去对准它
https://www.shititong.cn/cha-kan/shiti/0009ffad-f67e-419f-c0b8-ef8d402da900.html
点击查看答案
2637. A mechanical pressure gage on the oxygen cylinder shows the cylinder pressure regardless of the cylinder shutoff valve position
A. 无论气瓶的关断活门处于何种状态,氧气瓶上的机械压力表显示气瓶压力。
B. 当气瓶的关断活门状态正常时,氧气瓶上的机械压力表显示气瓶压力。
C. 无论气瓶的关断活门处于何种状态,氧气瓶上的电子压力表显示气瓶压力。
https://www.shititong.cn/cha-kan/shiti/0009ffb5-69cf-f585-c0b8-ef8d402da900.html
点击查看答案
3361. Attache the panel to the structure with the bolts
A. 用螺母将面板固定在支架上。
B. 用螺栓将面板固定在结构件上。
C. 用螺栓将面板固定在支架上。
https://www.shititong.cn/cha-kan/shiti/0009ffba-8e38-50b7-c0b8-ef8d402da900.html
点击查看答案
