A、 Get the approval of the design authority whatever it is necessary to change the repair scheme.
B、 Change the repair scheme, until getting the approval of the design authority.
C、 If it is necessary to change the repair scheme, get the approval of the design authority.
答案：C
A、 Get the approval of the design authority whatever it is necessary to change the repair scheme.
B、 Change the repair scheme, until getting the approval of the design authority.
C、 If it is necessary to change the repair scheme, get the approval of the design authority.
答案：C
A. The approved words were chosen because they are as simple as to be recognized.
B. If the words are difficult and hard to identify, they may not be selected as the approved words.
C. Simplicity and legibility are the main features of the approved words.
A. If there is a available service bulletin to correct the problem of moisture ingress into the connector cavity, the letter then will be useless.
B. Refer to this letter to help mitigate moisture ingress into the connector cavity even if there is a available service bulletin to correct the problem.
C. If there is a available service bulletin to correct the problem that moisture ingress into the connector cavity, the letter then will provide procedures.
A. 在需要折叠的书页上,折叠时应使页码可见。
B. 在手册的折叠页上,在折叠的地方应标示出页码。
C. 对于折叠页,应建立一个以页码为文件名的文件夹。
A. 确保维修飞机时不要撞到勤务箱。
B. 确保勤务车不要撞到飞机。
C. 确保勤务柜不要放在飞机的旁边。
A. 所有在此区域人员必须使用护目镜。
B. 所有在此区域人员必须使用防护服。
C. 所有在此区域人员必须使用呼吸设备。
A. 确保装置底部两个接线板粘合
B. 确保装置底部两个接口结合
C. 确保装置顶部两个接线板粘合
A. It is the responsibility of the operator to ensure that alternative tools or equipment can work well and are dangerous to the parts and personnel as the ones specified in the procedure if you use them.
B. If alternative tools or equipment are used, the operator must ensure that they can play the same role and are as safe as the tools or equipment specified in the procedure to the parts and personnel.
C. If the manufacturer car make sure that alternative tools or equipment can meet the requirement and are as safe to the parts and equipment as the ones specified in the procedure, you can use them.
A. Do an inspection of fuel leakage again.
B. Do a leakage test of filter assembly again.
C. Do a leakage check of the filter assembly again.
A. 应按要求提供允许的前、后重心限制。这些限制应针对认证的每一个机型。
B. 应按要求提供允许的前、后重心限制。这些限制应针对飞机认证的每一阶段。
C. 应按要求提供允许的前、后重心限制。这些限制应针对飞机认证的每一类别。
A. If the airspeed values are necessary to more than one configuration, the more restrictive IAS shall be used.
B. Where the airspeed values may be applicable to more than one configuration, the more conservative IAS value shall be used.
C. The more accurate IAS value should be used where the airspeed values are mandatory to less than one configuration.
