3037. Make sure that there are no loose objects in the engine air intakes

A. After the valid date of this amendment, a newly produced aircraft＇s pilot＇s manual must be approved by FAA.

B. After this revision date, FAA must approve a newly produced aircraft＇s pilot＇s manual.

C. After the effective date of this revision, Pilot＇s Operating Handbooks for newly manufactured airplanes must be FAA Approved Airplane Flight Manuals.

A. 当需要了解膜片时,使用箭头指示方向。

B. 必要时应使用箭头表示流向来理解原理图。

C. 利用箭头指示的方向来理解线路施工图。

A. The removal of the piston is involved in the steps

B. The removal of the piston is not included in the procedure

C. The procedure eliminates the piston

A. When taking off from the runway, deviation pointers in the ADF indicators show the pilot in which direction he/she must control the airplane.

B. During the approach to the runway, deviation pointers in the course indicators show the pilot in which direction the aircraft must go.

C. In the approaching process, deviation pointers in the flight path deviation indicator show the pilot how to control the aircraft.

A. After wash aircraft, all 3 landing gears were found un-lubricated.

B. After aircraft wash, all 3 landing gears were found un-lubricated.

C. After aircraft clean, all 3 landing gears was found un-lubricated.

A. There are trim tabs at the rear of both ailerons.

B. There are trim tabs at the rear of both flaps.

C. There are trimmable stabilizers at the rear of both elevators.

A. 球形轴承

B. 圆锥轴承

C. 圆柱轴承

A. 为了达到在整个行业内以合理统一的形式向飞行员提供与特定飞机操作相关的所需、有用或可取信息之目的,手册起草者应在实际可行的范围内遵循本规范。

B. 为了在整个行业内给飞行员提供要求的,有用的或想要的关于某架飞机的信息,建议手册的起草者在实际编写中遵守此规范。

C. 为了实现这样的目的,即在整个行业内给飞行员提供要求的,有用的或想要的某架飞机的信息, 必须采用统一的形式,手册的编写者要结合实际情况遵守此规范。

A. The Manufacture recommends that Buyer＇s qualified technicians inspect, troubleshoot test and repair or replace systems and components recommended by the Manufacturer that may be repairable o replaceable during normal maintenance procedures. The Manufacturer shall provide sufficient information in the Maintenance Manual and/or Maintenance data.

B. The Maintenance Manual and/or Maintenance Data provided by the manufacturer to the Purchaser shall contain enough information to enable qualified mechanics to inspect, troubleshoot test and repair or replace all systems and units that the Manufacturer regarded to be repairable or replaceable during normal maintenance procedures.

C. The Manufacturer shall provide the Purchaser with adequate information to enable the mechanics to do qualified work, such s to inspect troubleshoot test and repair or replace all systems and components that repairable or replaceable with reference to the Maintenance Manual and/or Maintenance Data ad required.

A. Normally for an aircraft that has tail wheels, you can tow the tail wheels forward. Todor this you can connect the tow bar to the main landing gear.

B. Usually, for an aircraft that has tail wheels, you can link the tow bar to the main landing gear, thus you can tow the aircraft forward.

C. For an aircraft that has tail wheels: you can tow the aircraft forward only when the tow bar is linked to the main landing gear.