A、 Make sure that the parts or surface layer are dry and free from uncontamination.
B、 Make sure that the parts or surface layer are dry and free from contamination.
C、 Make sure that the parts or surface lamination are dry and free from contamination.
答案：B
A、 Make sure that the parts or surface layer are dry and free from uncontamination.
B、 Make sure that the parts or surface layer are dry and free from contamination.
C、 Make sure that the parts or surface lamination are dry and free from contamination.
答案：B
A. The isolation blanket has a waterproof layer that is installed in a brick configuration to prevent leakage of condensed water into the carriage.
B. The insulation blankets have a waterproof layer and are installed in a tiled configuration to prevent leakage of condensed water into the compartment.
C. The insulating blankets have a watertight layer which is mounted in a shingled configuration to protect leakage of water condensation into the compartment.
D.
E.
F.
G.
H.
I.
J.
解析：
A. Print all pages besides wiring diagrams and foldouts on both sides.
B. Print all pages other than wiring diagrams and foldouts on both sides.
C. Print all pages no more than wiring diagrams and foldouts on both sides.
A. 本文件中的任何零件没有出版商的许可不得复制
B. 本文件中有任何一个部分是没有得到出版商许可的
C. 未经过出版商书面许可,本文件任何部分不得以任何形式复制
A. If the fault message still exist press AUDIO CANCEL push switch on the avionics test panel.
B. If the fault message continues, turn on the AUDIO CANCEL switch on the avionics test panel.
C. If the fault message keeps coming, turn off the AUDIO CANCEL switch on the avionics test panel.
A. If the number of failures is more than three, clean the unit.
B. If the number of failures is more than three, replace the unit.
C. If the number of failures is more than three, repair the unit.
A. Fuel sample was checked for contamination of microorganism.
B. Contamination to microorganism was detected in the fuel sample.
C. Fuel sample check reveals positive contamination of microorganism growth.
A. The wing has two precise dimensions which provide the wing position in inches.
B. The position of the wing is shown in inches by the two accurate configuration of the wing.
C. The location of the wing is presented in inches by the two reference dimensions of the wing.
A. Usually the jumper is non-conductor.
B. The purpose of using a jumper to connect pins 1 and 2 is to make them disconnected.
C. The purpose of using a jumper to connect pins 1 and 2 is to make them short.
A. The overall power package includes engine, air intake, mount, cowling, scoops, cowl flaps, cooling baffles, etc.
B. The engine inclusive of engine, air intake, mount, cowling, scoops, cowl flaps, cooling baffles, etc.
C. The overall power package inclusive of engine, air intake, mount, cowling, scoops, cowl flaps, cooling baffles, etc.
A. The dictionary includes some unapproved words that can be technical names if you can put them in the applicable technical name category.
B. Some approved words are included in the dictionary, they can be technical names if they belong to applicable technical name category.
C. The dictionary contains some unapproved words, which can be put, in separate technical name category, they can be technical names.
