3231. The microprocessor cards are interchangeable

A. Each section shall be started on a right-hand page.

B. Each section shall be started on a left-hand page.

C. Each section shall be proceeded from a right-hand column.

A. The thickness of the second coating layer must be 0.5mm and 0.6mm.

B. The coating thickness must be more than 0.5mm and less than 0.6mm.

C. The thickness of primer layer must be between 0.5 mm and 0.6 mm.

A. The lower washer comes into view during you pull the lower gear down

B. The lower seal comes into view when you pull the lower bearing down

C. The lower shim goes out of view while you pull the lower sheet down

A. Hydraulic fluid deflations as temperature increases;

B. Hydraulic fluid dilates as temperature increases;

C. Hydraulic fluid expands as temperature decreases;

A. Two systems can be energized at a time.

B. Two systems can be engaged at the same time.

C. Two systems can be adopted separately.

A. With the aid of the component manufacturer, all components in this chapter can be overhauled in any workshops with different qualifications.

B. Without the data supplied by the component manufacturer, it is possible for the most qualified shop to overhaul any components included in this chapter.

C. You must overhaul any or all components in this chapter in an eligible shop on the basis of data provided by the component manufacturer.

A. If the filters become clogged, send them to the laboratory for analysis of the contamination.

B. If the filters are surged, send them to laboratory for contamination analysis

C. If the contaminant is blocking the filter the material should be sent to the laboratory for analysis

A. 注:随后的测试中,当来自横穿进口的燃油流量超过8毫升/分钟时,将获得刮痕压力。

B. 注:随后的测试中,当来自交输进口的燃油流量超过8毫升/分钟时,将获得刮痕压力。

C. 注:随后的测试中,当来自交输进口的燃油流量超过8毫升/分钟时,将获得开启压力。

A. 告诉一个人撤轮挡

B. 告诉A撤轮挡

C. 告诉一个人拆刹车

A. Loosen the cotter nuts [10] on reducer [2] and bypass valve [8] on each end of air pressure filter assembly [4].

B. Loosen the swivel nuts [10] on reducer [2] and bypass valve [8] on each end of air pressure filter assembly [4].

C. Loosen the cross nuts [10] or reducer [2] and standby valve [8] on each end of air pressure filter assembly [4].